Review of Lippert RV Slide Out Parts - Head Parts - LC74AF Video

There is a gear in the housing of the Replacement 18:1 Venture Motor and Driveshaft with Right Angle Gear Box #LC117292 right by where you would bore through so you run the risk of it interfering with the operation of the motor. You'd also break…

I spoke with Lippert and found that their replacement for your PowerGear Slide Out Motor 13-1086 is the Replacement Gear Motor Assembly for Lippert Slide-Out #LC386321.

The Replacement 18:1 High Speed Motor Assembly for Lippert Components Venture Actuator and Slide-Out part #LC295380 is only offered by Lippert as a complete unit with the motor and gear. The motor is not available separately from Lippert.

There isn't a left or right hand version of the Replacement Idler Head and Roll Tube part #LC87FR that you referenced.

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

The amount of times you'd need to wind a Solera awning when installing it is 14 times. The part number you have 285148 matches up with the #LC87FR.

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

We have a few different slide out rollers so I've listed them below so that you can measure your current roller and see if we have a compatible match. I've separated them by surface mount and recessed mount as well. Surface Mount: Global Link…

There isn't an exact angle to go off of when it it comes to shackle straps, but we try to them to sit in a 'W' shape to allow for the suspension to travel without binding up. Depending on the length of the shackle straps the angle can…