Lippert Components RV Awnings LC388169 Review Video

The Solera switch part #LC285500 that you referenced was designed to fit all Solera power awnings so it would work well to give you an inside switch to extend and retract. This would not affect the batteries ability to charge either.

The Solera 18V Power RV Awning Conversion Kit - Universal - 69" Arms - White #LC434730 does use a lithium-ion battery. The Replacement is 18.5V Lithium-Ion Battery for Solera 18V Power RV Awning #LC387959 if ever needed. Lithium batteries work…

I spoke with someone from Lippert and I was told that you need to let the power arms charge for a full 24 hours. They also sent me trouble shooting steps, which I have included below. From Lippert If your battery is not charging properly: 1. If you…

For your Solera Universal Awning Support Arms for RVs - 18 Volt Power - 69" Arms - Black #LC434729 we do have the replacement charging cable available. It is part #LC388169. I confirmed this fit with my contact at Solera.

The best replacement we have for the Sylvania Microwave SR-11092B is going to be the Greystone Microwave part #324-000105. This microwave comes with its own frame that will need to be used but it should cover your cut out so you will never be able to…

I have a solution for you. You can see it linked below: **Greystone Standard RV Microwave w/ Trim Kit - 1,350 Watts - 0.9 Cu Ft - Stainless Steel #324-000106. This unit will fit into the built in space of your old microwave. Or if you wish it can be…

I took a look around at the Lippert literature but I'm having trouble finding a wiring diagram for the Replacement Switch for Solera 18V Power RV Awning #LC644584. The good news is that these wires are connected to the head so you can just…

If your trailer has the Lippert Ground Control 3.0 jack system installed then yes, the charger part #LC267401 would be the correct fit for it. Does your remote look like the picture I attached? What you see in the picture is the remote this charger…

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

On a towing setup you are always limited by the lowest rated component as the overall towing capacity since that is the weakest point. When it comes to trailer tires you always want to have them inflated to their max psi when cold. Not only do you…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…