Review of Edge Performance Chip - Pulsar V3 L5P Inline Tuner With Insight CTS3 Monitor - EP34KR Video

The Edge Pulsar V3 L5P Inline Tuner with Insight CTS3 Monitor #EP34KR allows for higher power numbers than the Edge Pulsar L5P Inline Tuner with Insight CTS3 Monitor #EP29YR. This is because it utilizes the more updated version 3 of the Pulsar versus…

If your Thor Motorhome has a cable entry plate like part #34273840 on the roof then yes, you can attach the Go Power Overlander Expansion Kit #34282182 to it. You'll also need a controller like the PWM Solar Charge Controller #34280503 so you can…

Yes you'd easily be safe to add another Go Power Overlander Expansion Kit #34282182 to your GoPower setup that has a 30 amp controller. You'd be close to the max amperage but you'd be under the 30 amps pretty easily even if they were at…

I contacted the manufacturer to confirm that the Go Power Overlander Expansion Kit #34282182 could be added to your Go Power 170W panel on your RV with the GP-PWN-30 controller. They were able to inform me that you could add up to 2 of the Go Power…

The Superchips Flashpaq F5 Performance Tuner #SU2845 will not void the warranty. I do see you entered your vehicle as a 2019 Chevrolet Silverado 3500 which you will need the Tuner #SU2847 for as the other is not compatible with your specific gas…

Thank you for the pictures, using the provided pictures I was able to tell that you have the Furrion Vision S wireless system. You have 3 monitor options for that system and I have listed them below. For a 4.3" monitor you can use the…

Your photo shows the OBD-II connection. This port is used for vehicle error codes and diagnostics. If your 2018 Toyota Tacoma has a factory 7-way trailer connector, then the Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In…

The brake controller install harness on your 2017 Toyota Tacoma can be hard to find but the part #3031-P will fit it. If you check out the picture I attached you will see where a customer found the connectors in a Tacoma just like yours.

The brake controller connector is clipped to the back side of a panel located just to the right of the ignition key. You'll need to lower the panel and unclip the connector from the rear of the panel, then feed it down behind the panel so it…

For your 2019 GMC Sierra 2500, I believe the pucks are a standard size of other manufacturers but they do space them out differently. You can use the Replacement Puck Plug Covers for Elite and Signature Series Fifth Wheel Rails (Qty 2) #58199.

I have a solution for you. Unfortunately, the Superchips Flashpaq F5 #SU2845 only works with the 6.0L v8 engine on 2019 GMC Sierra 2500 HD models. With that being said, the tuner that will provide you with a lot of the same type of tunes as the…

The connector for the #3031-P Brake Controller wiring harness is located behind a panel just to the right of the steering column as shown in the linked install instructions, the video and the provided photo.