Review of Dexter Axle Trailer Leaf Spring Suspension - 007-126-01 Video

I have an option for you, but unfortunately we do not sell a kit with just the wet bolts and bushings for the Lippert Road Armor on your 2019 Keystone Montana High Country 375FL. I recommend the Bronze Bushing #D014-077-00 which is 9/16"…

The torque requirements for leaf spring u-bolts depend on the diameter of the u-bolts that are being used. If the gross weight of your tandem axle trailer is 7,000 lbs, then you likely have two 3,500 lb axles. Typically 1/2 inch diameter u-bolts…

The Dexter Shackle Bolt for Double Eye Springs #007-126-01 measures 2-1/4" from bolt head to threaded portion. This bolt is 2-7/8" long and has a thread size of 7/16"-20. You can use Replacement 7/16"-20 Flange Nut #LC122103 with…

Trailer manufacturers don't usually keep a record of parts like these that they install at the factory, so I cannot be sure as to the exact length of the shackle strap that would have come originally on your trailer. With this in mind, a 3-1/8…

Thank you for the images. The MORryde Rubber Equalizers #MR87ZR are the correct set for your 2020 Keystone Outback Ultra-Lite 291UBH. You will pair this with the MORryde Suspension Upgrade Kit #MR46ZR. Instead of using the wet bolts included with the…

It does sound like you have found some clear damage to your 5th wheel trailer's leaf springs that will require attention. Uneven tire wear can be caused by a number of things - incorrect pressure, inadequate weight on the axle or a visibly…

The correct nut for the Dexter Shackle Bolt for Double Eye Springs part #007-126-01 is the Replacement Flange Nut for Dexter Trailer Suspension Kits part #006-092-01.

With the info you listed I was able to determine that you have a 5 lug 2,000 lb capacity hub no so for a replacement you would want the #AKIHUB-545-2-G-EZ-2K that you referernced. This comes with bearings and an ez lube cap as well.

There should be enough free play in the shackles to allow them to move. There is no specific torque rating for shackle bolts. The first thing you should make sure of is that the bolts you use are long enough so that when installed you will have at…

The MORryde X-Factor Crossmember for CRE, SRE, or Stock Leaf Spring Suspension #MR33WR includes one adjustable crossmember. Your existing hardware will be too short due to the extra thickness of the crossmember, so you will need to add #MR58ZR if…

The MORryde X-Factor Crossmember part #MR33WR is designed for standard suspension so that is the one you will need to use. If your leaf spring hanger brackets are wider than 3" then you will need to drill per the instructions which I have…

The MORryde X-Factor Crossmember part #MR33WR attaches to the leaf spring hangers which are located in-between and in the front and rear of each axle. I have attached a photo below to clarify. Therefore, you'll need three for full support on a…