Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C56226 Review Video

Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…

The relay location on Nissan vehicles can be interesting. A lot of times on the Frontier it's behind the kick panel on the passenger side like where you checked but the other common location is under the dash to the left of the steering wheel…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The only way to order a 7-way for your 2016 Nissan Frontier is to go with the part #C56226 which includes the jumper harness and relays. The good news is that you would have spares in case you were to damage a relay. If you happen to already have the…

On wiring harness #C56226 the larger brown relay is for the 12 volt circuit on the 7-Way and the two smaller blue relays are for the turn signal circuits so none of them would cause the constant power draw on the blue brake wire but I think I know…

Your 2009 Nissan Xterra does not require a converter for a trailer connector. It uses the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector #C56226 which plugs into the factory connectors in the rear of your…

Other than the fact that each 7-way trailer connector you mentioned is from a different manufacturer, both the #C56226 from Curt and the #118266 from Tow Ready would work identically. Either connector would work just fine on your Xterra. You could…

The heaviest rated hitch we have available for your 2013 Nissan Pathfinder is the Curt #C13126. This Class III 2 inch is rated for 600lbs tongue weight and 4,000lbs towing capacity; if used in combination with a weight distribution system it will…

Since the solution for no running lights on your 2013 Nissan Xterra is a missing relay and you also want a 7-way kit your best solution would be the part #C56226. You already have some of the relays but you'll be able to use one of the extra blue…

Yes. The Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector #C56226 is a fit for your 2010 Nissan Pathfinder and utilizes the relays you referenced in the Curt Relay Kit for Nissan Aftermarket Tow Package…

Your 2007 Nissan Frontier will have the tow package, as will all models, and the reason there are relays with the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector #C56226 is that they will activate that tow…

Yeah I'm not sure why it was written like that. The only way to repin the #C56226 is to cut and resplice them, unfortunately.