Camco Propane - Hoses - CAM59053 Review Video

In order to correctly measure a propane hose you will need to measure end to end (fitting to fitting). The propane hoses we sell are by the foot so this may make it easier to determine what you need. It is also a good idea to get a hose that is a bit…

In order to connect two 20 lb propane tanks to one another you are going to need a regulator with an auto changeover feature like the Camco Automatic Changeover 2-Stage Propane Regulator part #CAM59005. This regulator will pull from one tank until…

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

I am sorry to be the bearer of bad news Gregg but your Voyager camera WVCMS130AP is part of the first gen camera system, which we no longer carry since it's been discontinued by the manufacturer. Voyager was considerate enough to make sure their…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…