Review of Camco Heater Stand - CAM57701 Video

The Camco Olympian Wave 8 Catalytic Safety Heater, #CAM57351, is adjustable from 4,200 to 8,000 BTUs. It appears their rating of using 1/3 lb per hour is operating at, while not maximum, a high setting. A gallon of propane contains 91,502 BTU. There…

The dimensions of the Camco Olympian Wave 8 Catalytic Safety Heater for Large RVs #CAM57351 are 15" long x 4" wide x 21-1/4" tall. There isn't an exact set safe clearance stated with this heater but Camco strongly recommends having…

The highest BTU rated version of the Camco Olympian Wave Heater is the part #CAM57351 which is adjustable from 4,200 to 8,000 BTUs and will heat approximately 290 sq. ft. This is also approved for use in Canada.

You can control the settings of the Camco Olympian Wave 8 Catalytic Safety Heater for Large RVs #CAM57351 but not the specific temperature. As you can see by the accompanying photo, the heater has three settings: Low, Medium and High.

I am not sure how your Camco Olympian Wave 8 Catalytic Safety Heater for Large RVs, part #CAM57351, is adjusted. If you are burning propane at 0.18 lbs/hr, that rate is almost 50% less than the 1/3 lbs/hr consumption rate that Camco says you should…

I went out to the warehouse to measure Camco Olympian Wave 3 Catalytic Safety Heater part #CAM57331 and the unit no longer has the knobs and buttons on the front. The black knob is on the left side of the unit and the red switch is on the left side…

I reached out to my contact at Camco regarding the Olympian Wave 3 Catalytic Safety Heater #CAM57331 and he said the heater requires at least 4" of clearance on each side and at least 30" of clearance from the front of the unit (where the…

The front of the Buyers Products Trailer Tongue Toolbox part #3371701680 is 18-1/4" wide which you can see in the attached photo.

Based on some research, I was able to find out that your tandem axle 2019 Lance 1995 travel trailer has a GVWR of 5,700 lbs, and does use Dexter Torflex torsion axles like you mentioned, so the correct lift kit is the Torflex Lift Kit - Tandem Axle…

The flame is supposed to go out when you switch the valve from "start" to "high". Check out the demonstration video I attached which goes through the whole process of starting and using the Camco Olympian Wave 3 Catalytic Safety…

As long as the fully loaded and ready to tow weight of the trailer is less than the 4700 lb towing capacity of your 4Runner, you can tow the trailer as long as the factory installed hitch has sufficient capacity. The hitch should have a ratings…

I recommend using the Camco Low-Pressure LP Gas Regulator w/ 12' Long Hose #CAM57721 for your Camco Olympian Wave 6 #CAM57341. This comes with 12' of hose which is a bit shorter than what you're wanting, but the flip side of that is you…