How Much Heat Shield Trimming is Require to Install Hitch C12115 on a 2010 Buick LaCrosse
Question:
have to trim a lot off heat shield
asked by: cal n
0
Expert Reply:
For the Curt Class II Trailer Hitch Receiver, # C12115, there is no heat shield trimming. But you will need to trim a small section of the fascia on each side of the vehicle. Take a look at the instructions linked to the right for more details.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch that Fits 2013 Chevy Malibu LT
- Q&A: Replacement Hardware for Draw-Tite Max-Frame Trailer Hitch Receiver
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Concealed Cross Tube Hitch Recommendation For 2019 Chevy Impala Premier
- Q&A: Troubleshooting Installation of Curt 12115 Trailer Hitch Receiver
- Q&A: Recommended Trailer Hitch For 2019 Chevy Impala That Has The Best Ground Clearance.
- Q&A: E-Bike Rack Recommendation for 2015 Chevy Impala
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Which Hitches are Made in the USA
- Article: How to Install a Trailer Hitch
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Hitch Receiver Sizes