Fit of Westin E-Series # 23-1680 Stainless Tube Steps on 2011 Silverado 2500 Extended Cab

Question

Question:

Hello, My truck is a 2011 Chevrolet Cheyenne 2500 CAB-EXT B Z71 4 X 4, motor 5.3 lts. I want to know if the 23-1680 is the step bar for my truck. Thanks in advance for your help.

asked by: Arnoldo T

0

Expert Reply:

The Westin Stainless Steel tube steps, part # 23-1680 are indeed a fit for your 2011 Chevy Cheyenne (Silverado here in the USA) 2500 Extended Cab truck.

If you'd care to see other accessories for your truck, click the provided link.

expert reply by: Mike L

0

click to enlarge

Answer 1

Yes, the Westin E-Series Step Bars, item #23-1680, comes with all the necessary hardware for an easy, no drill installation on your Vehicle.

view full answer...

Answer 2

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 3

The difference between the Firestone Dual Air Command Systems #F49VV and F46VV is the the former is only controlled by a smartphone while the latter can be controlled by a smartphone but it also comes with a Bluetooth remote so you don't have to…

view full answer...

Answer 4

I am not sure exactly which model of Kauffman gooseneck trailer you have, but the easiest way to adapt to a 5th wheel hitch will be to use a coupler adapter. This will replace the gooseneck coupler inner tube with a traditional fifth wheel kingpin.…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 6

To replace the step pad on a Westin E-Series Nerf Bar like the #23-1680 you'll need to use the Replacement Step Pad for Westin E-Series Nerf Bars - 21" Long x 3" Wide - Qty 1 #23-0001, which will work on any of the 4 spots these pads…

view full answer...

Answer 7

The replacement bracket and hardware kit for your 2500 crew cab are the Replacement Installation Hardware for Westin Platinum Series 4" Oval Nerf Bars part #21-195PK.

view full answer...

Answer 8

From the picture you provided, it looks like you have the Westin E-Series 3" Round Nerf Bars #23-1680 which is confirmed to fit your 2008 GMC Sierra 1500 extended cab. The correct replacement hardware kit is #23-168PK. If your running boards are…

view full answer...

Answer 9

The installation for the Westin Tube Steps, part #21-1685, is a three point attachment. I have attached a photo that shows the center bracket installed. These steps are custom fit and require no drilling when installing. They bolt to the existing…

view full answer...

Answer 10

I went out to the warehouse and pulled Curt forged ball mount #C45456 to measure it for you. The width at the platform is 3-1/16 inches wide. And in case you were curious, the platform is 1 inch thick.

view full answer...

Answer 11

The Westin E-Series nerf bars #23-1680 come with all of the needed hardware to install. All you need is basic hand tools and a little bit of free time for the install and you'd be set.

view full answer...

Answer 12

The correct replacement hardware for your Westin E-Series Round Nerf Bars - 3" - Polished Stainless Steel #23-1680, is the Replacement Hardware for Westin E-series Step Bars #23-168PK.

view full answer...

Fit of Westin E-Series # 23-1680 Stainless Tube Steps on 2011 Silverado 2500 Extended Cab

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching