A-Frame Jack Recommendations with High Capacity and High Lift
Question:
I need to replace the a-frame jack on my camper. I created a special adapter for my drill to use with the corner jacks and it works great. I am looking for an a-frame jack that somehow may be adaptable as well. I guess one that has a removable handle with a stud of some kind would work. Also the jack needs 5000 lb capacity. If possible a lift that is 15 inch or more would be good as well.
asked by: Thom P
Expert Reply:
I believe your best option would be the etrailer.com Round A-Frame Trailer Jack - Sidewind # TJA-5000S-B. This A-frame jack has a 5,000 lb capacity and has 15 inches of lift. There is no way to remove the handle or any of the other 5k jacks so that it could be operated with a power drill.
A powered jack like the part # SC63VR might be a better option. This is the highest rated powered jack we have at 4,500 lbs and has 23 inches of lift.
I attached a review video for you to check out.
Products Referenced in This Question
Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- etrailer
more information >
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 4,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 4001 - 5000 lbs
- Electric Jack
- 23 Inch Lift
- Bolt-On
- 1 Jack
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Q&A: Alternative Ways to Power the Ultra-Fab Electric A-Frame Jack
- Q&A: Smaller Trailer Tire Than 215/75R14 w/ 5 on 4-1/2" Bolt Pattern To FIt in Garage
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Q&A: How to Find Connector for Back Up Sensors When Installing 118760 Trailer Wiring on 2019 Honda Pilot
- Q&A: Wiring 3-Wire Breakaway Switch as Replacement for 2-Wire Switch
- Q&A: Correct Grease Seal for a Boat Trailer that 10-19 Seal won't Fit