A-Frame Jack with Foot Plate Recommendation

Question

Question:

Im looking for an a-frame jack with a foot. Is there one available?

asked by: Mike F

0

Expert Reply:

Yes, check out the Pro Series Round, A-Frame Jack # PSEA2000-14007. It is an a-frame jack that comes with a foot that should work well for you.

expert reply by: Jameson C

0

Answer 1

The best option we have to replace an old Dometic awning arm is with the Solera Classic Universal Awning Support Arms part #LC434716 for 63"-68" or part #LC434718 for 68"-81". This is a universal kit that will allow you to keep…

view full answer...

Answer 2

The Solera Smart Arm 12V Power RV Awning Conversion Kit #LC759516 that you referenced does work with the Dometic A and E roller tubes like you have and would reuse their end caps as it does not come with them.

view full answer...

Answer 3

The best way to select the correct size vinyl trim insert is to measure the trim insert you have now while flat, not the track. We don't really recommend measuring the track as they are not all a standard width. That said, we only offer vinyl…

view full answer...

Answer 4

You can change your cam locks to slam latch locks but it will take modifying your hatch doors. You can use the Global Link RV Baggage Door Slam Latch with Keyed Alike Option - Black - 1-1/2" Thick #295-000015 along with the Global Link Mounting…

view full answer...

Answer 5

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution. It's correct length at 23-1/8 inches and is for a 3,500 lb trailer axle like you have as well.

view full answer...

Answer 6

All of the electrical readings you are getting on your electric brakes sound normal and the lower amperage readings are likely due to additional resistance due to the longer wiring used on the rear axle. It sounds like there is either an issue with…

view full answer...

Answer 7

There isn't really a right or wrong answer when it comes to selecting trim for the tops and sides of your trailer. It is really just about selecting the best shape/style/size that fits your contours the best. Trim like the Top Rail Trim for…

view full answer...

Answer 8

Good question and the 2,000 lb working load limit (WLL) of the Erickson Horizontal E-Track such as the 5 foot #E19148 is the safe limit for the weight of the cargo the track is helping secure. To simplify, it is the cargo capacity that the track can…

view full answer...

Answer 9

The working load limit for the E-Track system like the part #E19148 that you referenced is 2,000 lbs. There isn't a set method required for tightening a load to the E-Track. Basically you would want to use a properly rated strap for the weight of…

view full answer...

Answer 10

Thanks for the picture of the a-frame jack mounting bolt hole dimensions you have. Based on that we know you have a standard jack mount on your trailer and the Stromberg Carlson Electric Trailer Jack #JET-5000 you are interested in is a confirmed fit…

view full answer...

Answer 11

I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…

view full answer...

Answer 12

If you have the ACTH12 then you should also have the Air Distribution Box #ACRG15 which will have a control box for your wiring from the rooftop unit #ACM135 and the thermostat. This air distribution box and thermostat will wire up exactly the same…

view full answer...

A-Frame Jack with Foot Plate Recommendation

Product Page this Question was Asked From

Continue Researching