Pilot Diameter of the Wheel and Tire part # AM3H300

Question

Question:

Pilot diameter of the Kenda 215/60-8 Bias Trailer Tire with 8" Galvanized Wheel # AM3H300

asked by: Russell B

0

Expert Reply:

I went out into our warehouse and measured the pilot diameter of the Kenda 215/60-8 Bias Trailer Tire with 8" Galvanized Wheel # AM3H300 and found it to be 2-1/2 inches.

expert reply by: Jameson C

0

Answer 1

I have a wheel and tire that is very close to what you are looking for, except it doesn't have a negative offset. The Kenda Trailer Tire with 8" Galvanized Wheel #AM3H300 has a 215/60-8 size tire and a wheel with a 4 on 4 inch bolt pattern.…

view full answer...

Answer 2

The wheel used on the #AM3H290 has a zero offset, which means that the mounting plate of the wheel that sits against the face of the hub is in the center of the width of the wheel. Because the tire is about 9 inches at its widest, you'd be…

view full answer...

Answer 3

We can help you select new wheels/tires for your 1983 Rockwood pop-up camper. The linked page displays all 4-on-4 wheel/tire combinations we offer. These come already mounted together and are offered in various tire sizes. All you need to do is note…

view full answer...

Answer 4

If you are referring to the Kenda 215/60-8 Bias Trailer Tire with 8" White Wheel part #AM3H290 then the backspacing will be 4". This however is not a constant amongst all 8" diameter x 7" wide trailer wheels as the offset will…

view full answer...

Answer 5

The 8 x 7 inch wheel used on the #AM3H290 wheel/tire combo does indeed have a zero offset. I have confirmed this with Americana Wheel.

view full answer...

Answer 6

No, unfortunately it is not true that over-inflating a tire allows it to be driven faster, nor can it carry more weight. It is never appropriate to under- or over-inflate a trailer tire for any reason. Trailer tires should ALWAYS be inflated to the…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Pilot Diameter of the Wheel and Tire part # AM3H300

Product Page this Question was Asked From

Continue Researching