What is the Capacity of the Trailer Valet Jack and Trailer Mover

Question

Question:

I have a 27 ft boat. After reading the comments I kind of worried. What is the limit on this product?

asked by: Kathleen L

0

Expert Reply:

The Trailer Valet, # STC-V211, is rated for 500 pounds tongue weight. Typically boat trailer tongue weights are lower than regular trailer tongue weights because boats are heavier at the back. The unit has a 5,000 pound gross trailer weight capacity.

expert reply by: Michael H

0

Answer 1

Yes, when installing the knob for the Redarc Tow-Pro Liberty Brake Controller item #RED24FR you will want to remove any extra material behind the insert. I am happy the video was able to help you out. I have linked a couple of pictures from the video…

view full answer...

Answer 2

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 3

I have a set that will work however your 2023 Chevy Suburban's owners manual says not to use tire chains because of clearance issues on the inner part of the tires. You can find this information on page 370. To avoid damaging brake lines and…

view full answer...

Answer 4

The NOCO Genius charger part #329-GENIUS2 that you referenced would perfectly for this. It is a 2 amp charger that once the battery is fully charged will switch to a lighter charge to maintain it when stored so that when you need to use the truck it…

view full answer...

Answer 5

What you need is a little bit of momentum to get the boat trailer over the lip of your garage floor. If you can get the trailer moving at a decent speed (while still maintaining control), the momentum of the trailer will carry it over the lip.

view full answer...

Answer 6

To connect the reverse wire from the Tekonsha OEM Replacement Vehicle Wiring Harness #TK57VR to your 2022 Toyota Highlander you'll need to route it up the paneling at the back of your Highlander, through the boot that connects from your vehicle…

view full answer...

Answer 7

If you don't see any bolts holding the existing jack onto the trailer frame, it might have been installed by welding it in place. If this is the case, you'd need to grind off the welds, which is something you'd probably need a…

view full answer...

Answer 8

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…

view full answer...

Answer 9

Thank you for the photo, it was beneficial in determining that you will be fine using the Trailer Valet 5X Swivel Jack #STC-V211 with your V-Nose trailer. I called Trailer Valet, and they told me that the top crank was roughly 7 inches long. If you…

view full answer...

Answer 10

I will start by saying the ARK Extreme Off-Road Ratcheting Trailer Jack w/ Wheel #ORJW1SU will fit frames that are 2" to 6" tall. The bolt hole measurements vary and I included a diagram with everything listed, but the overall dimensions of…

view full answer...

Answer 11

I wasn't sure exactly what dimension you were looking for on the mounting bracket of the Trailer Valet part #STC-V211 so I attached a picture that has nearly every dimension for you to check out.

view full answer...

What is the Capacity of the Trailer Valet Jack and Trailer Mover

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching