Battery Box for Breakaway Battery

Question

Question:

looking for a small battery box for a Hopkins battery sa1250f0-02 12v5.0ah dimensions 3 1/2 L - 2 3/4 W - 4 H, if available an cost thanx grant.

asked by: Grant S

0

Expert Reply:

We do indeed have a battery box that's specifically designed for that battery. The part number is # HM20120.

You can see current pricing by clicking the provided link. The box can be ordered online by using the provided link.

expert reply by: Mike L

0

Answer 1

I believe the vent cover you are looking for is the Replacement Dome for Fan-Tastic Vent RV Roof Vents - Tinted #FVK1020-19. I've attached a video to assist. I've also attached the 4 hinge options in a photo to give you a clear look at the…

view full answer...

Answer 2

I spoke with Fan-Tastic Vent and was able to use the model number you provided "FV6350LWUSD81" to confirm that you need the Replacement Dome for Fan-Tastic Vent RV Roof Vents part #FVK1020-19 as this is the correct replacement for your roof…

view full answer...

Answer 3

We have a online diagram that will help you understand how the break away system is wired into your trailer. It is actually a simple installation. The system splices into the existing trailer wiring. The break away box will have 3 wires coming out of…

view full answer...

Answer 4

I ran out to the warehouse and pulled one of the battery boxes off the shelf, and took several measurements off of it. If you refer to the photo I have edited, you can see the dimensions of the outside of the box.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Since your frame is 2 inch wide we have the Torklift battery box part #TLA7735 which would be what you'd need but the #TLA7736 would not work as it was designed to fit a 2-1/2 inch wide frame.

view full answer...

Answer 7

I spoke to my contact at TorkLift about the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box part #TLA7740 and they informed me that you would not be able to mount two 6 volt batteries side by side in the box due to the limited…

view full answer...

Answer 8

The brake wires can be spliced together and have one wire run to the junction box if that is easiest for you. On a single axle you could also have separate brake wires for both sides if you wanted to but most of the time there is a single wire out to…

view full answer...

Answer 9

I do have a handy trailer wiring FAQ article that would be perfect for you. I have included a link to it. I have also included a picture that shows the typical wiring diagram of a 7-Way round pin trailer side connector. As you can see, the 7-way…

view full answer...

Answer 10

Based on your dimensions it sounds like you need a box for a trailer breakaway battery. All of the replacement breakaway battery boxes we offer can be seen on the link provided. For example, the inside of part #TK2018 measures 5-3/8 L 3-1/16 W…

view full answer...

Battery Box for Breakaway Battery

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching