6-Way Wiring Diagram Request

Question

Question:

Need to know the diagram for plug-in with 6 pole ,but only 5wires

asked by: Kenny

0

Expert Reply:

I attached a picture that shows how 6-ways are typically wired. Looking at your picture it doesn't look like the colors will match up and you will need to wire by function instead of by color. Most likely the missing circuit on your 6-way wiring is the 12 volt power circuit as this circuit is the most frequently not used.

expert reply by: Jameson C

0

click to enlarge

Answer 1

For a wheel that is 5 inches in width and 15 inches in diameter you would want tires that are size ST205/75-15. For the tire size ST225/75R15 you listed you would want a rim that is from 6-7 inches in width. I attached a department page that has…

view full answer...

Answer 2

We do stock wheel and tire combos like the size ST175/80R13 part #TA43RR that looks like you are in need of. This has the standard 5 on 4-1/2 inch bolt pattern and thankfully all trailer wheels have a zero offset so you do not need to also verify…

view full answer...

Answer 3

In order for your Blue Ox Alpha to work with the Roadmaster EZ4 Base Plates, part #RM-523160-4, you need an adapter like part #RM-032. In addition to the tow bar and base plates, you will need a system to join the tail lights of the motorhome to…

view full answer...

Answer 4

Yes, you can flat tow a vehicle with a Roadmaster base plate with a Blue Ox tow bar as long as you get the correct adapter like the part #RM-032 to connect the two. This is the style of adapter for the Roadmaster base plates that have to use a…

view full answer...

Answer 5

I attached a diagram that shows how most 7-way rounds like the #PK11720 that you referenced will get wired up. As long as you got yours wired up correctly and your trailer taillights and brakes are functioning correctly that's all that should…

view full answer...

Answer 6

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

view full answer...

Answer 7

Any given tire will fit a range of rim widths. The ST225/75-15 tire will fit 6, 6-1/2, and 7 inch rims, but not a 5 inch rim. The tire will not be able to seat properly on the rim and you will not be able to keep air in it or safely use it. As far as…

view full answer...

Answer 8

The lights sockets you refer to are indeed available without the rest of the kit. You would need part #RM-155-2, which you can see by clicking on the provided link.

view full answer...

Answer 9

To protect the 12 volt accessory power supply circuit, we recommend using a 40 amp inline circuit breaker, part number 9510.

view full answer...

Answer 10

The wire gauge of the blue wire on the Hopkins Adapter 4 Pole to 5 Pole Trailer Wiring Adapter, part #47515, will be too small to be able to use as a 12 volt power source. You will need to use a 10 gauge wire on your truck to run a 12 volt power wire…

view full answer...

Answer 11

A 12V trailer power circuit will typically be wired with 12-gauge wire, part #12-1-1, but certainly there is no harm in using heavier 10-gauge wire #10-1-1. If one tow vehicle is longer than another, our installers may opt to use the heavier gauge…

view full answer...

Answer 12

Generally, the center pin on a standard 7-way is used for reverse lights on the trailer. However, not all trailers have reverse lights and essentially you can wire the extra pin anyway you'd like. Normally, the pin in the 1 O'clock position…

view full answer...