Brake Controller Wiring Harness for a 2006 Chevy Silverado 2500HD

Question

Question:

wich harness do i need to connect to my truck, thanks 2006 chevrolet 2500 hd

asked by: JIm

0

Expert Reply:

For a 2006 Chevy Silverado 2500HD you will need brake controller wiring harness # 3015-P for a Tekonsha, Reese, or Draw-Tite brake controller.

Chevy trucks also some times need additional connections under the hood to make everything fully functional. I have included a link to a help article that explains this for you. I have also included a link to a video showing the harness being installed on a similar truck.

expert reply by: Michael H

0

Answer 1

There are times when it is tough to locate the brake controller plug under the dash. On the 2015 Ram the factory plug is located between the brake pedal and the emergency brake pedal as shown in the attached photo. It is probably behind another…

view full answer...

Answer 2

Both races you mentioned are related to the same bearing, #L68149. The difference in the races is the outer diameter. The outer diameter is important for the hub that the race fits so because the hub bore in the rotors is different than the hubs you…

view full answer...

Answer 3

To install the Tekonsha Prodigy P3 Trailer Brake Controller #90195 in your Freightliner S2RV chassis the wiring is behind the kick panel in the drivers compartment. There is not a connector on the wires, they are simply terminated with tape. You will…

view full answer...

Answer 4

Your 2014 Chevy Traverse that has the factory 7-way does not require accessing the brake controller wiring if your plan was to install the Curt Echo Mobile brake controller part #C74VV that you referenced. Basically you'd plug in the Echo…

view full answer...

Answer 5

The only difference in the Demco Channel Tongue Trailer Couplers #DM16080-95 and #DM15931-95 is going to be the bolt pattern. One will have the 5-Bolt hole pattern and the other is going to have 4-Bolt holes. I have included images below showing the…

view full answer...

Answer 6

I would start by determining the towing capacity of the vehicle. I did some research, and saw a range of 2000-5200 lbs depending on how the vehicle was equipped. If you phone your Chevy dealer, they should be able to tell you the towing capacity of…

view full answer...

Answer 7

It sounds like you just need to figure out which wires are supposed to go where for the installation of the Kwikee Step Motor Conversion/Upgrade Kit #LC379145 on your 1997 Georgie Boy. I am attaching a wiring diagram for the control module for you to…

view full answer...

Answer 8

Step 8 in the instructions for the Ranch Hitch Universal 5th-Wheel-to-Gooseneck Coupler Adapter #AM3100 states the following: 8) Locate the grade 8 bolts, lock washers, nuts and your drill and bit. There are eight holes drilled in the Ranch Hitch…

view full answer...

Answer 9

I have attached a photo with the mounting dimensions of the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames part #UF35-946403. The brackets are 2" long x 4" wide x 3" tall. If you need any other measurements then please let…

view full answer...

Brake Controller Wiring Harness for a 2006 Chevy Silverado 2500HD

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching