Replacement Hardware to Install Draw-Tite # 75270 on a 2014 Odyssey

Question

Question:

Hello. Im moving Draw-Tite trailer hitch 75270 from a 2002 Honda Odyssey to a 2014 Odyssey. I am wondering if it is possible to purchase new bolts, washers, and spacers. Thanks

asked by: Matt R

0

Expert Reply:

Replacing the hardware is an excellent idea. The hardware isn't really meant to be reused.

To find the replacement hardware kit, click the provided link for part # RHK. Once you're on the page, type the hitch part number 75270 and manufacturer, Draw-Tite into the provided fields as shown in the diagram I provided.

expert reply by: Mike L

0

click to enlarge

Answer 1

For the Draw-Tite trailer hitch, #75270, or any of the trailer hitches we carry, the torque specifications can be found after the last step in the installation instructions that are linked on the page. Because the design of a hitch could change or…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

From what little I was able to learn about the VelociRAX 5 bike rack on their website, the rack is compatible with a 2 inch hitch that has a tongue weight capacity of at least 500 lbs, and the Draw-Tite #75270 Class III hitch meets both those…

view full answer...

Answer 5

The primary difference is a matter of numbers. When installed, the Draw-Tite Class III #76025 will sit so the inside top edge of the receiver tube sits about 13 inches above the ground, and the receiver tube will sit under the bumper so that the…

view full answer...

Answer 6

I have exactly what you need to add a 7-way trailer connector to a 2016 Honda Odyssey. For this, you'll need to start with a 4-way trailer connector and I recommend the T-One Vehicle Wiring Harness part #118521 which is plug-n-play. Then you can…

view full answer...

Answer 7

The custom fit receivers we offer do come with the appropriately sized/pitched bolts. If anything we get phone calls where the 1.25 bolts seem too big. If you have any issues trying to get the bolts into the existing weld nuts on the van we recommend…

view full answer...

Answer 8

Having the puck system is a great feature. If you ever plan on loading the bed with mulch, sand or rock you'll quickly find that having rails permanently bolted to the bed floor is a real pain. Not only that, but the pucks look a lot better.…

view full answer...

Answer 9

I looked up the instructions for the Draw-Tite hitch, part #75270, and the torque specification for the 6 M12 bolts is 68 Lb.-Ft. I have added a link to the instructions below so that you can review them. The torque rating is just above the small…

view full answer...

Replacement Hardware to Install Draw-Tite # 75270 on a 2014 Odyssey

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching