Replacement Upright For CE Smith Bunk-Style Guide-Ons

Question

Question:

I have a c e smith trailer bunk kit their part 315057. I need a replacement upright. Is your part number 27609pg the correct one?

asked by: Michael D

0

Expert Reply:

Hey Michael,

Thanks for the info, and the part number you referenced is actually one from a different retailer, but using that I was able to track down that you were referencing the CE Smith Bunk-Style Guide-Ons # CE27600.

And you do indeed have the right replacement upright for those guide-ons, the Replacement Upright for CE Smith Bunk-Style Guide-Ons for Boat Trailers # CE27609PG.

expert reply by: Kyle S

0

Answer 1

I am not totally sure which CE Smith Guide Ons you have but we have the part #CE27605PG which fits the #CE27640 and #CE27760. This is 39 inches tall. For a 18 inch tall section you'd want the part #CE27608PG or if you have the upright that angles…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 4

Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…

view full answer...

Answer 5

As long as the weight capacity is inline with your trailer/axle rating and the measurements match your current springs, the number of leaves in a spring pack does not matter. The difference between a 3 and 4 leaf spring pack within the same weight…

view full answer...

Answer 6

Hello again, James. We will need to consider a different approach here because the Timbren Silent Ride Suspension like part #TSR3500S05 cannot be used with torsion axles. In order to use the Silent Ride you would need to completely replace both…

view full answer...

Answer 7

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Replacement Upright For CE Smith Bunk-Style Guide-Ons

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching