E-Bike Rack Recommendation with Ramp that is Rated for Flat Tow Use

Question

Question:

I flat tow a 2020 Chevrolet Colorado, I have two E bikes approximately 120lbs. total weight w/out batteries. Would it be possible to use the Hollywood destination rack, with the ramp for the ease of loading or is it not possible?

asked by: Jay

0

Expert Reply:

I have a great solution for you Jay but the Hollywood Racks Destination isn't rated for use at the rear of a flat towed vehicle. Instead the only option similar that would work is the Yakima OnRamp part # Y36FR which is rated for this application, has the needed weight capacity and comes with a ramp setup as well.

expert reply by: Jameson C

0

Jay L.

3/6/2024

I’m sorry I didn’t mention that one of the bikes has 4.0 inch tires. Thanks for responding, but I’m still looking for a rack that will work.

Reply

Jameson C.

3/11/2024

@JayL Ah bummer, we don't have any solutions with ramps but the Hollywood Racks RV Rider part # HLY64FR would work great aside from the ramp aspect.

Reply

Answer 1

Vehicle suspensions are built with comfort in mind and put much less stress on a bike rack, whereas RV suspensions are a lot less sophisticated and will bounce a lot causing a lot of stress on the bike rack. Over time this stress can cause the bike…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 4

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 5

You should not need an extension for the Hollywood Racks Destination E Bike Rack #HLY66ZR to fit on your 2021 Jeep Wrangler Unlimited Sport. We installed this on a 2021 2-door Wrangler which I have included the install video linked near the bottom of…

view full answer...

Answer 6

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 7

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 8

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 9

At the rear of a trailer or RV the ride quality is very rough when compared to the ride quality at the rear of a passenger vehicle. Reason being the suspension isn't as sophisticated and there is a longer distance between the rear axle and the…

view full answer...

Answer 10

The Tow Defender #RM-4700 you found is really our best option to protect the front of your 2024 Chevrolet Trax. This screen helps to deflect any road debris back down to the ground to keep it traveling under your Trax. This particular cover is…

view full answer...

Answer 11

For an e-bike rack for your Letric XP step thru bikes at the rear of an RV the Swagman E-Spec part #S94FR would be a great choice as it's rated for the rougher ride quality at the rear of RVs, has the higher weight capacity needed at 60 lbs per…

view full answer...

Answer 12

In order to use a hitch-mounted bike rack like the Swagman Original #S64152-2 that you were looking at while towing a vehicle, you will just need to add the Roadmaster Dual Hitch Receiver Adapter #RM-077-4. This adapter will slide into the 2 inch…

view full answer...