Can the Spring Bars on an Equal-i-Zer WDS Be Swapped Out

Question

Question:

I lost a bar to my 16000, eq64fr, hitch. I do not need the 16000 weight gtw. Can I replace the missing bar with this 1400 bar. thanks

asked by: Roger S

0

Expert Reply:

Yes you can just swap out the bars on your Equal-i-zer Weight Distribution System w/ 4-Point Sway Control # EQ64FR with the Replacement Spring Bar for Equal-i-zer Weight Distribution Systems # EQ90-02-1499.

expert reply by: Bryce D

0

Answer 1

Unlike some weight distribution systems, the weight distribution head of the Equal-i-zer hitches also carries a bar-specific weight capacity so you unfortunately wouldn't be able to increase the weight capacity by just going with a higher rated…

view full answer...

Answer 2

The longest folding ramps we have for you is the Arched Loading Ramp Set part #288-07432 for 1 or part #288-07432-2 for 2 which are 90" long. The 90" length will ensure the angle that will be required to load the generator in your truck bed…

view full answer...

Answer 3

For most golf carts you want to go with a 1,000 lb capacity loading ramp. I would however recommend the Erickson Arched Ramps part #EM07486 as they have a 3,000 lb capacity, an aluminum construction which will make them lightweight, and straps that…

view full answer...

Answer 4

Replacement spring bar for 1000 pound Equal-I-Zer systems #EQ90-02-1099 is 36 inches long and 1-3/8 inches wide. The different Equal-I-Zer systems have different heads for the different spring bars so as long as you currently have the 1000 pound…

view full answer...

Answer 5

It could be some sort of issue with the steel on your Equal-I-zer weight distribution system #EQ37140ET. Frequent overloading of the hitch could also cause this issue. I'm not saying that you overload the system but that is just one possibility.…

view full answer...

Answer 6

I spoke my contact at Equal-i-zer and he told me that since it has 1 1/2" bars it is probably rated for 12,000 lbs. He said the way to tell for sure is to measure the bolt channel. If it measures 3/8" it is a 12,000 lb hitch, if it measures…

view full answer...

Answer 7

When changing the spring bar rating of a Fastway e2 weight distribution system like you are wanting to do with the part #FA92-01-1299 you do not have to change to a different head. So all you need is the upgraded spring bars and you'd be set.

view full answer...

Answer 8

The Husky Center Line Weight Distribution with Sway Control 32217 is for 600 lb to 800 lb total tongue weight capacities (the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your tow…

view full answer...

Answer 9

What you really want to do when choosing a weight distribution system is try to get as choose to the middle of the systems capacity as possible. The typical tongue weight of a trailer will be anywhere from 10% to 15% of the total weight of the…

view full answer...

Answer 10

Sounds like you are looking for the Replacement Sway-Control Bracket for Equal-i-zer Weight Distribution #EQ95-01-5600 which is the exact same bracket that comes with the Equal-I-Zer kit part #EQ64FR that you referenced.

view full answer...

Can the Spring Bars on an Equal-i-Zer WDS Be Swapped Out

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching