Replacement Corner Plugs And Seals For A TruXedo TruXport Tonneau Cover

Question

Question:

I have a TruXport Tonneau cover on my 2015 GMC 2500HD and need to replace the front corners. The serial number on the cover is 032398808 but I can not determine what model the cover is. Will these fit?

asked by: Jay G

0

Expert Reply:

Yes, the Replacement Cab End Corner and Weather Seal Kit for TruXedo TruXport Tonneau Covers # TX1118262 would be a compatible fit for your cover. If you need to replace the rear caps as well then you'll need part # TX1704534, # TX1704535 , and # TX1703568.

expert reply by: Kevin C

0

Answer 1

You're going to have to purchase the entire kit if even if you only need one side. The Replacement Cab End Corner and Weather Seal Kit for TruXedo TruXport Tonneau Covers #TX1118262 is only sold as a complete kit.

view full answer...

Answer 2

If you are having trouble leveling the trailer using the auto-level feature then I first recommend extending each jack leg out at least 6" inches and then pressing and holding the retract button until the legs have fully retracted. This should…

view full answer...

Answer 3

The best method to identify the tonneau cover on your 2008 GMC Sierra will be to look for the date code and or serial number. The serial number is located on the driver's side of the front header on the TruXport frame. The date code is printed on…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

The Triple-Axle Trailer Hanger Kit #APTT3 that you referenced is designed to work on axles with capacities of 2,000 lbs to 7,000 lbs so it should work very well for you. I attached a picture that has a chart that shows exactly how you should space…

view full answer...

Answer 7

In order to calculate where the axles would go on your trailer, there are several things that need to be taken into consideration. You will have to mock up the trailer with the suspension and axles to get the weights needed to determine where the…

view full answer...

Answer 8

Different trailer configurations require different equalizers. It all depends on the springs, axle spacing, hanger spacing, height needed and so on. In many cases if you want to change the equalizer to something with different measurements you would…

view full answer...

Answer 9

In the image with the suspension setup the equalizer #TREQ105 is placed between the front and second axles. Just like you have on your trailer. The front of the equalizer connects to the spring using a shackle strap and the rear is connected directly…

view full answer...

Answer 10

Equalizers for trailer suspension have different shapes, lengths, and heights to accommodate different axle spacing, spring lengths, and deck heights. Going to an equalizer that is not the same length and height as the original will require replacing…

view full answer...

Replacement Corner Plugs And Seals For A TruXedo TruXport Tonneau Cover

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching