How Can I Tell If I Have A Manually Controlled Distribution Box Or Not?

Question

Question:

What is manually controlled Furrion Air Distribution Boxes. And how can you tell what we have

asked by: Winston H

0

Expert Reply:

A manually controlled distribution box has the controls built into the distribution box (ceiling register) itself. An example of this is part # FACT11MA-PS. The best way to know what you have is to look at how your air conditioner is controlled. If you have to reach up above your head to turn the air on and off, you have a manually controlled distribution box. Otherwise, it will be electrically controlled by a wall thermostat, like part # FACT12SA-PS.

I see that you were looking at the Furrion Heat Strips. We offer the # FR35SR for manually controlled distribution boxes, or the # FR27PR for the electrically controlled units.

expert reply by: Jesse M

0

Answer 1

After installing The Furrion Heat Strip Add-On for Furrion Air Conditioner #FR27PR on your Jayco Jay Feather 27BHB the heating strip is utilized using the existing thermostat. This heating strip will work best in smaller spaces where the temperature…

view full answer...

Answer 2

Your Furrion Chill Replacement RV Air Conditioner for Furrion Setup - 15,000 Btu - Black #FR86PR is definitely not functioning correctly. We haven't seen this issue yet with that model, but it isn't uncommon that air conditioners when they…

view full answer...

Answer 3

The Furrion Chill HE 13.5K A/C does not have a hand remote, however it does have a wall-mounted thermostat which you can turn the unit on or off. You can add a heating strip as well if you'd like with the Furrion Heat Strip Add-On for Furrion Air…

view full answer...

Answer 4

You can absolutely add heat to your Furrion Chill air conditioner, and all you need in order to do so is a heat strip from Furrion, which you can get with the following part: - Furrion Heat Strip Add-On for Furrion Air Conditioner #FR35SR

view full answer...

Answer 5

The Furrion Heat Strip Add-On for Furrion Air Conditioner #FR35SR you looked at is the correct heat strip for the FACR14SA-PS. You will also need the Replacement Air Distribution Box w/ Built-in Thermostat for Furrion Chill RV Air Conditioner…

view full answer...

Answer 6

The Furrion Heat Strip #FR27PR is the one your need for a Furrion AC with the single zone thermostat. This kit will include the heat strip as well as a new controller to work with your air conditioner. It can be used with both single zone and multi…

view full answer...

Answer 7

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

How Can I Tell If I Have A Manually Controlled Distribution Box Or Not?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching