Recommended Replacement For A Marshall 605H LP Regulator

Question

Question:

My trailers current MARSHALL CONTROLS 605H LP dual tank regulator seems to allow gas to leak from the connection IF I remove a tank and the other LP gas is ed and open. Is that normal? If not, please provide recommendations for a replacement regulator. I can send a photo of the regulator if needed. Thanks!

asked by: Carlos P

0

Expert Reply:

The valve in your regulator is likely going bad and allowing the gas leak so you would want to replace it. I recommend swapping it out with the JR Products Compact Automatic Changeover 2-Stage Propane Regulator # 37207-31525. This has 1/4" FIF inlets and a 3/8" FPT outlet.

expert reply by: Kevin C

0

Answer 1

The Marshall 605H RV Propane Regulator is a pretty standard two stage auto changeover regulator for low pressure systems. In order to replace this, I recommend the JR Products Compact Automatic Changeover 2-Stage Propane Regulator part #37207-31525…

view full answer...

Answer 2

Thanks for the picture! To replace your Marshal 605H propane regulator you will need to go with the Camco Vertical 2-Stage Propane Regulator #CAM59313. This will be an exact replacement for your current regulator. I included a video review of the…

view full answer...

Answer 3

We have what you are looking for but your regulator currently vents out of the bottom of the regulator and the one you referenced vents out of the side. So to match the correct orientation you'd want the part #CAM59313.

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 6

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

view full answer...

Answer 7

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 8

The primary advantage of frame-mounted camper tie-downs like the TorkLift #TLF2012A and #TLF3001A, which are designed to fit your Ford F-350 if it has the 6-3/4 foot bed without a step/board underneath and a factory hitch, is the stability they…

view full answer...

Answer 9

There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…

view full answer...

Answer 10

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 11

That is correct, you can tap into the plug and it will provide a charge but keep in mind that this is not the most efficient way for charging a battery. This method does not provide any charge balancing or battery charge management and on newer…

view full answer...

Recommended Replacement For A Marshall 605H LP Regulator

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching