Can Furrion Vision S System be Activated with Running Light and Ground Circuit of Trailer Wiring

Question

Question:

Hello. Looking to purchase a wireless rearview camera system Furrion for full time viewing of oncoming traffic and for the bicycles on the hitch mounted bicycle rack on the back of our 25 RV. Is it possible to power the wireless camera mounted low on the bike rack by utilizing the 4 pin trailer plug brown and ground? Thanks.

asked by: Dave

1

Helpful Expert Reply:

Yes, you can power the camera of the Furrion Vision S system part # FOS43TASF with just the running light circuit and ground circuit which will allow you to switch it on anytime you activate the running lights or head lights.

expert reply by: Jameson C

1

Answer 1

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 2

The Furrion cameras, like what comes in the part #FOS43TASF that replaced the part you referenced, are only compatible with their specific monitors. If you are looking for a camera system that allows you to use your smartphone as the monitor then I…

view full answer...

Answer 3

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 4

The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be a…

view full answer...

Answer 5

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Answer 6

If the Forest River Rockwood Mini Lite Travel Trailer came pre-wired then there will be a sharkfin camera mounting bracket at the top of the trailer in the rear. This bracket will then allow you to purchase one of their cameras to use with their…

view full answer...

Answer 7

You can have more than one iPhone "connected" to the Lippert Tire Linc system part #LC37VR but only one can be used at a time. So basically you or your wife could have their phone connected but if you needed to switch between the two phones…

view full answer...

Answer 8

Though the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will offer you more support when fully loaded, they will also affect your ride a lot more when not loaded. Even at the lowest setting (5 psi). I really only recommend…

view full answer...

Answer 9

We have 2 different remotes available for HappiJac electric camper jack systems. - Replacement Remote Control for HappiJac Electric Camper Jack Systems #LC723915 - Replacement Remote Controller for Wireless HappiJac Electric Truck Camper Jacks…

view full answer...

Answer 10

The newer Chevrolet and GM pickup trucks have a known power deficiency issue with the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras #FCE48TASL-05. There is likely nothing wrong that you did, the problem is the…

view full answer...

Answer 11

There is a wireless camera you can use for your travel trailer that will always be on. It is the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision item #FOS05TASF. It comes with a 5" monitor and you will want to wire the camera…

view full answer...