Is There a Demco Brake Line Extension or a Longer Brake Line Kit Than the DM5426 Kit

Question

Question:

Do you have a 3ft steel line extension with coupler for the DM5426 kit? Im 3ft short of long run and everything else in the kit looks about right.

asked by: Dan L

0

Expert Reply:

I do not see an extension kit for the Demco Hydraulic Brake Line Kit for Single Axle Trailers # DM5426. However, you can just step up to the Demco Hydraulic Brake Line Kit # DM5643 which has the additional main line (long run) length that you are needing.

expert reply by: Scott S

0

Answer 1

Hey Jeremy, sorry for the confusion but no the replacement cable for the Dexter Breakaway kit part #T2385500 does not come with the cable that attaches the longer cable to the handle. If you need that as well you'd be best just replacing the…

view full answer...

Answer 2

How long of a line do you need? Do you know what size you need? The most common size is 3/16 inch like part #BH-3MFS-4-5 which is 54 inches long.

view full answer...

Answer 3

Hey Kevin, for your Demco DA70 actuator you can use the Reverse Lockout Solenoid for Demco Hydraulic Brake Actuators #DM11993.

view full answer...

Answer 4

We have a few different parts for Toledo actuators but not a master cylinder rebuild kit. We have the master cylinder that you referenced, #10614. We also have a replacement shock, #1844-2, a pivot bushing, #1745, and a pivot shaft, #1829. If your…

view full answer...

Answer 5

The brand Toledo that makes the part #10614 that you referenced is manufactured by the company Mendanhall Industries.

view full answer...

Answer 6

Indeed they are; you can use the same replacement shock absorber and master cylinder for your Balcrank Actuator 16030, which are the following parts: - Replacement Master Cylinder for Toledo Drum Brake Actuators #10614 - Replacement Shock Absorber…

view full answer...

Answer 7

The only way to get a new control panel would be to replace your entire Smart Jack with part #LC643589. I reached out to my contact at Lippert who confirmed that the only replacement parts for the jack includes hardware like the pin or the footplate.…

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Is There a Demco Brake Line Extension or a Longer Brake Line Kit Than the DM5426 Kit

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching