Replacing Bearings On A 1985 Holsclaw 1,000lb Boat Trailer
Question:
Im looking for a wheel bearing kit for my 1985 Holsclaw, 1000-lb, boat trailer. Do you have any suggestions?
asked by: Eric
Expert Reply:
I can certainly point you in the right direction. Unfortunately I am not able to recommend bearings based on just a year, make and model of trailer. If only it were so easy right? We would need to have you measure and verify some info. Specifically we would need to know bearing numbers/sizes. If you can remove and unpack a hub we should be able to identify the sizes. Especially since the trailer is almost 40 years old, as they did not use the same standard bearing sizing back then as they do now.
A lot of smaller trailers today will use bearings like the # L44649 (1.063" inner diameter) or a # L44643 (1" inner diameter. Since your trailer is only 1,000 lbs I am assuming that it has a light duty axle that would use one of these smaller bearing sizes or something similar. Only one way to know for sure and that is to unpack a hub and see for yourself.
I have included a picture that shows the measurements needed for a spindle, bearings, seals, faces, and hubs.
Products Referenced in This Question
Replacement Trailer Hub Bearing - L44643
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.000 Inch I.D.
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- etrailer
more information >
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44643
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.000 Inch I.D.
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- etrailer
more information >
Continue Researching
- Shop: Washer For 1" Spindle
- Q&A: Availability of Spindle Washer for Boat Trailer
- Search Results: spindle washers
- Search Results: retractable ratchet straps
- Search Results: boat trailer guide posts
- Video: Review of TruRyde Washer For 1 Inch Spindle - SW1000
- Search Results: axle washer
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Video: Choosing the Best Trailer Bearing Races Caps and Seals
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Blue - 12' Long x 11" Wide
- Shop: Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal
- Search Results: 44649
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Trailer Wiring
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Shop: Grease Seals 10-36 (pair)
- Search Results: 68149
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Shop: Brake Controller
- Search Results: 25580
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: Fifth Wheel Hitch
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778