Is Progressive Dynamics Replacement Section # PD4645V Compatible with Lead Acid Batteries

Question

Question:

will this converter charge lead acid batterys

asked by: Taylor, L

0

Expert Reply:

Yes, the Progressive Dynamics Replacement Section # PD4645V that you referenced is compatible with lead acid batteries.

expert reply by: Jameson C

0

Answer 1

Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V is what you need as a replacement lithium compatible converter for your 6345 Parallax model.

view full answer...

Answer 2

Yes, the Progressive Dynamics Converter #PD4645V can be switched to a lithium profile. This is a recent update for this converter which is why there is some outdated info out there on it. A jumper is basically just a small switch on the circuit…

view full answer...

Answer 3

Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V is what you need as a replacement lithium compatible converter for your 6345 Parallax model.

view full answer...

Answer 4

We have valve stem extension kits like the part #WM8001-135 which were designed for use with dually wheels like what you have on your 2016 Ford F-350.

view full answer...

Answer 5

The instructions for the Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp #PD4645V have multiple model numbers on them since each model has basically the same installation instructions. They do breakout each model…

view full answer...

Answer 6

Yes, you can safely upgrade to the 45 Amp Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V for a more powerful system but to get the full benefits you'd have to pretty much upgrade your whole electrical system so it…

view full answer...

Answer 7

The Replacement Converter for Parallax/Magnetek Power Centers item #PD4645V you were looking at is the most direct replacement for the Magnetek 6300 series at 45 amps. It will work with flooded lead acid, AGM, gel batteries, and is made in the USA.

view full answer...

Answer 8

If you wanted to make your 12 volt power circuit turn off when the vehicle is turned off you could install the isolation solenoid part #PK5231201 on the circuit. You'd need install the circuit to the outside posts and then for the center pin…

view full answer...

Answer 9

The only converter cross-section compatible with a Magnetek 6345 or Parallax 7345RU is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V, which unfortunately is not compatible with lithium batteries. You would need to…

view full answer...

Answer 10

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...