Moving Jumper Over on Progressive Dynamics to Convert to Lithium Profile
Question:
Hi, we have a PD4060K converter and we are upgrading to LiFePO batteries. The manual shows a LA lead acid/LI lithium switch. However, ours has a jumper as in the attached photo. Does the jumper need to be moved? Do we need a new converter?
asked by: Noah W
0
Expert Reply:
Yes, you do need to move the jumper over from the lead acid to the lithium setup and you'd have the higher voltage charging profile.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Progressive Dynamics 4000 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 60 Amp
- RV Converters
- Smart Charge
- Standard Charge
- 10-3/4L x 7-1/4T Inch
- 12V
- 60 Amps
- Lead Acid
- Lithium
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Change The Progressive Dynamics PD4060K Power Center To A Lithium Charging Profile
- Shop: B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring
- Shop: Yakima SlimShady Awning - Roof Rack Mount - Clamp On - 4' 6" Long x 6' 6" Wide
- Q&A: Is There a Difference Between Progressive Dynamics Converter # PD4655V and # PD4655LIV
- Q&A: Replacing American CS6000XL in Camper
- Article: Trailer Tire Sizing
- Q&A: How to Use Lithium Batteries With a PD4060K Converter/Panel That Does Not Have the Li Switch
- Article: 4-Step Guide to Installing RV Solar Power
- Q&A: Does AC/DC Distribution Panel Need Separate Grounds for AC and DC Sides
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Does Lithium Battery Really Need a Different Charging Setup Than Other Batteries
- Q&A: How to Convert Parallax 7300 Model 7355 to Work with Lithium Batteries
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Best RV Roof Vents
- Article: How to Measure for Trailer Hitch Drop