Replacement Wiring Harness for Solera SmartArm Awning for Rain Sensor

Question

Question:

My Jayco doesn’t have the wire connection installed to connect to this. Where can I get the connecters that match this item?

asked by: Ricky S

0

Expert Reply:

We have a replacement wiring harness for the Solera SmartArm awnings with the part # LC56ED but if your current awning does not have correct connectors for use with the rain sensor part # 919061654 it is possible you don't have correct awning to add the rain sensor to.

expert reply by: Jameson C

0

Answer 1

To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…

view full answer...

Answer 2

I reached out to Lippert on the Replacement Solera SmartArm RV Awning Controller Wiring Harness #LC56ED and the wiring coding is as followed: #1 White = Light Ground #2 Red - Power #3 Black - Awning Motor #4 Red - Extend 12V Input #5 Red - Awning…

view full answer...

Answer 3

I attached a picture of the wiring diagram for the Solera Smart Arm 12V Power RV Awning Conversion Kit #LC759404 that you referenced.

view full answer...

Answer 4

I may have a solution for you to convert a manual awning to a powered awning, but I checked with Lippert on this and there is not a 63" version of the Solera 18v Power RV Awning Conversion Kit like the #LC434730. However, if you're looking…

view full answer...

Answer 5

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 8

Sorry Jennifer, I am a bit confused as you were looking at the Replacement U-Clamp Bracket #RM-B141 which mounts with bolts and not U-bolts. This part works with the Split Bushing #RM-205217-10 for the discontinued Roadmaster Front Anti-Sway Bar…

view full answer...

Answer 9

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 10

To replace your Atwood RV Water Heater, Model #GC10A-4E, the direct replacement is the Atwood RV Water Heater - Gas and Electric - part #AT94022. This is the new version of your existing water heater, so it will have all the same features like a…

view full answer...

Answer 11

Hi Joe, The Blue Ox Base Plate Kit #BX1139 is a confirmed fit for your 2024 Jeep Wrangler Rubicon X per Blue Ox. I don't currently have an installation video on a model with a steel bumper but I did measure from the mounting holes down to the…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...