Is There a Replacement Air Spring for a Firestone 4118 Air Spring Kit on a 2020 Nissan Pathfinder

Question

Question:

have the coil rite air helper spring kit 4118 I need 1 replacement airbag. It is for a 2020 Nissan pathfinder.

asked by: Kathy S

1

Helpful Expert Reply:

I was able to verify with the manufacturer that the correct replacement air spring for the Firestone Coil-Rite Air Helper Springs # F4118 on your 2020 Nissan pathfinder is air spring 6118. The bad news is that the replacement air springs are no longer available.

While it is far from ideal, if you are needing a replacement air spring for the 4118 system, you'd have to get the entire # F4118 kit or find one second hand.

expert reply by: Scott S

1

Answer 1

Based on my research, a 2005 Jayco Jay Feather did come with a Torflex torsion axle, and we do have a single axle lift kit that may work. I say "may" because without knowing the exact model axle you have, there isn't a way to guarantee…

view full answer...

Answer 2

Thank you for purchasing Firestone rear air bag kit #F4164 for your 2015 Toyota Sequoia that has coil springs. To replace the damaged air line you can use kit #FWR17600048 which is 18-feet of air line hose that is already equipped with the 1/4-inch…

view full answer...

Answer 3

I do have an option for you but there would be no way to lift your trailer using your existing half torsion axle system as they just don't make anything to allow for this. The only option you have to raise the trailer would be to install a new…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

Hey Tarek, for your 2023 Ford Raptor I recommend checking out the Timbren Suspension Enhancement System #T75MR. This suspension enhancement system has a load leveling capacity of 3,000 lbs, will increase stability while reducing sag, and will install…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 12

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...