Troubleshooting a Remote for an AirLift Performance 3P That Is No Longer Working

Question

Question:

I got a issue with my airleft 3p, When I start the vehicle the controller didn’t turn on so what should I do the fix the controller?

asked by: Yankaiwang

0

Expert Reply:

The first thing I'd check is for a blown fuse. This is going to be one of the more common reasons why your remote stopped working, because there is no power to the unit. If the fuse is blown, simply replace the fuse and check for functionality.

If your fuse is good, then your batteries in your remote may be finished and would need to be replaced.

Finally, if all that is good then you're going to need to check all your wire connections to make sure they are not damaged as that could also be causing your issue.

expert reply by: Bryce D

0

Answer 1

Generally this is an issue with the remote #AL73002 communicating with the system #AL74000, a blockage, or a leak. I would inspect the compressor system and all of the air lines to make sure there are no issues. You can check for leaks using soap and…

view full answer...

Answer 2

Start off by double checking that you have everything installed correctly and that you have installed two CR2032 batteries in your Remote for Air Lift WirelessONE Compressor Systems #AL72704. If you check out the attached clip from the instructions…

view full answer...

Answer 3

The design of the Hitch Gooseneck Trailer Hitch #GY73XR doesn't really allow for much in the way of security. The only thing you can really do is replace the safety pin that secures the T-handle with a lock. This would prevent anyone from lifting…

view full answer...

Answer 4

It sounds like the compressor system may not be getting power or is not waking up. Depending on how the Air Lift WirelessONE Compressor System #AL25980 is wired to your vehicle you may have to do additional steps. The wiring harness has a ignition…

view full answer...

Answer 5

Generally this is an issue with the remote #AL73002 communicating with the system #AL74000, a blockage, or a leak. I would inspect the compressor system and all of the air lines to make sure there are no issues. You can check for leaks using soap and…

view full answer...

Answer 6

I went to the warehouse and pulled one of the Remote for Air Lift WirelessONE Compressor System, part #AL72704. I have attached a photo of the remote you can check out. On each side of the remote in the areas with the red arrows, there is a small tab…

view full answer...

Answer 7

I do have some info on how to change the batteries in your Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs #AL72704. I took a look at the instructions of the Air Lift WirelessONE Compressor System #AL25980 and…

view full answer...

Answer 8

To get your remote #AL72704 to work properly, you will need to sync it since the battery was replaced. To sync the remote use the following steps: 1. Turn ignition on. 2. Locate the sync wire in the wire harness of your Air Compressor. It will be the…

view full answer...

Answer 9

According to Air Lift, there are a few things that can cause this issue. The problem is likely an air leak between the manifold and the compressor or simply a weak compressor that would need to be replaced. To get the compressor running again so you…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Troubleshooting a Remote for an AirLift Performance 3P That Is No Longer Working

Product Page this Question was Asked From

Continue Researching