Troubleshooting Remote Not Working When Batteries Were Replaced
Question:
I have the airlift 7204 remote. The powerr in the remote went off. I replaced the batteries but still no power. Is there a trick to getting this remote to turn on?
asked by: John
Expert Reply:
To get your remote # AL72704 to work properly, you will need to sync it since the battery was replaced. To sync the remote use the following steps:
1. Turn ignition on.
2. Locate the sync wire in the wire harness of your Air Compressor. It will be the yellow wire that is looped with a yellow cap around it.
3. Remove the yellow wire from the cap leaving the cap attached to the harness.
4. Disconnect power to the receiver. Unplug the connector on the top.
5. Connect power to the receiver while grounding the sync input.
6. Listen for 3 clicks of the internal solenoid, then one click every second. This will indicate that you are now in the “sync mode”. Sync mode will last for 30 seconds total. Within the 30 seconds press any button on the transmitter to send a message to the receiver. Once the receiver has received a message it will sync with that transmitter and stop clicking the solenoid in 1 second intervals.
7. Reinsert the yellow wire terminal into the molded cap.
Richard
1/17/2020
I have the airlift wireless one brand new just put on my truck. I tried everything to get remote to work but all I get is a green light when hit button and then it goes red tried different battery’s but still does the same. Any ideas??
Product Page this Question was Asked From
Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs
- Accessories and Parts
- Air Suspension Compressor Kit
- Vehicle Suspension
- Remote Control
- Air Lift
more information >
Continue Researching
- Shop: Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs
- Shop: Suspension Enhancement
- Q&A: Troubleshooting Air Lift WirelessONE Remote Not Working
- Q&A: Air Lift 72704 Remote Not Working.
- Shop: Replacement Remote Control for Air Lift WirelessONE Compressor System
- Shop: Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs - Rear Axle
- Q&A: The Remote Says Fail, Is There A Reset On The Air Lift WirelessAIR Compressor System
- Search Results: disc brake conversion kit
- Video: Air Lift Vehicle Suspension AL72704 Review
- Q&A: Difference Between Air Lift WirelessONE Compressor Remotes
- Shop: Solera XL 12V Power RV Awning - 16' Wide - 9'8" Projection - White Fade
- Shop: Fifth Wheel Hitch
- Search Results: air lift controller
- Search Results: air lift wirelessone
- Shop: B&W Patriot 5th Wheel Trailer Hitch w/ Slider - Dual Jaw - 18,000 lbs
- Q&A: Reset for Air Lift WirelessAIR Compressor System
- Search Results: breakaway
- Shop: Air Lift WirelessAIR Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount
- Q&A: How to Change the Batteries of Air Lift Remote Control for WirelessONE Compressor 25980
- Shop: JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ Less Than 58" Between Landing Gear
- Q&A: Troubleshooting AirLIft Wireless Controller with Error Message
- Search Results: air lift
- Search Results: air lift
- Shop: Trailer Hitch
- Video: Air Lift WirelessONE Compressor System Remote Control Replacement Review
- Video: CIPA Slip On Towing Mirrors Review
- Shop: Towing Mirrors
- Search Results: air lift compressor
- Video: Review of Air Lift Air Suspension Compressor Kit - Gauge Panel and Switch - AL26161
- Video: Fastway ONEstep Tandem Axle Wheel Chock Review
David V.
2/16/2020
I replaced the batteries in my remote and yes I know u need to sync it but when u press the buttons it doesnt light up or turn on , thats needs to be on before u can sync it ? Correct ? So if it doesnt turn on its broken ?