Overall Bracket Dimensions of Alumi Tread Manual Pull Out Step # LC432696

Question

Question:

Looking at LC432696 steps to replace steel Hickory Springs steps on my 2010 Keystone Raptor 5th wheel. The Lippert steps look like an exact aluminum substitute. The product pageinch lists an overall width of 27.5inch which will work fine. But the dimensioned photo shows 28. This is too wide for the existing brackets welded to the RV frame. Which is correct? l

asked by: Edgar W

0

Expert Reply:

When we had an Alumi Tread Manual Pull OUt Step part # LC432696 in our photo room we found that the overall width of the mounting bracket was 27-3/4 inches.

expert reply by: Jameson C

0

Answer 1

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you,…

view full answer...

Answer 2

According to my research, AL-KO 8490 references an AL-KO hub for 3,500 lb axles with a 10 x 2-1/4" drum and a 5 on 4-1/2" bolt pattern. For a drum assembly that will work with these hubs I recommend taking a look at the Electric…

view full answer...

Answer 3

The Hayes Air Actuated Trailer Brake Controller - 1 to 4 Axles - Proportional #HA100400C mounts to the inside of your 2007 Nemar Essex at the dash just like other electric brake controllers will. It needs to be installed on the inside of the vehicle…

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

Good news, I can help you find a tire for your Sundown Horse Trailer. The 205/90-15 is a close tire size to the 7.00-15. The closest size to a 7.00x15 tire that we offer would be a 225/75-15. One 225/75-15 tire that could work for you is the Kenda…

view full answer...

Answer 6

I believe I have a solution for you, but I think you may need to remeasure your cutout and/or compare the measurements of your current latch with one of ours. Since latches tend to be fairly universal in size when it comes to the RV world the Global…

view full answer...

Answer 7

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 8

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Overall Bracket Dimensions of Alumi Tread Manual Pull Out Step # LC432696

Product Page this Question was Asked From

Continue Researching