Does Optronics LED Submersible Trailer Light # STL8RB Offer License Plate Illumination

Question

Question:

existing lights on my trailer have licence plate illumination do led tail lites not offer plate illumination

asked by: Rob

1

Helpful Expert Reply:

The Optronics LED Submersible Multifunction Trailer Light # STL8RB that you referenced is a right-hand light and does not include the clear down-facing lens for illuminating your license plate. However, the matching left-hand light from Optronics, part # STL9RB, does include this function.

Please refer to the linked photo which shows the underside of part # STL9RB.

We also offer a rustproof polymer License Plate Mount Bracket, part # LP10SB from Optronics, to allow installation of both the left-hand light fixture and license plate.

expert reply by: Adam R

1

click to enlarge

Answer 1

Hi Richard! It sounds like you're needing to install the Load Resistor Kit for LED Turn Signals #DI34ZR on the turn signals you've installed on your toolbox. Since LEDs don't require as much power as incandescent bulbs, sometimes we see…

view full answer...

Answer 2

Hi John, Yes, we do have everything you'll need to flat tow your 2024 Chevy Trax. Baseplate: Blue Ox Base Plate Kit #BLU24UR. Tow Bar: etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates #e47ZR. This tow bar comes with safety cables included…

view full answer...

Answer 3

We can get you a good replacement, though there is actually no longer a TDE brand. But that actuator is simply a bolt-on, 7,500 lb actuator that couples to a 2" hitch ball, and per the owner's manual does not have a lockout (so it is for…

view full answer...

Answer 4

We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a section…

view full answer...

Answer 5

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution. It's correct length at 23-1/8 inches and is for a 3,500 lb trailer axle like you have as well.

view full answer...

Answer 6

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 7

The Grease Seal part #168233 has a double lip so it can be used on a boat trailer and be submersed under water, yes. This is also the correct replacement for the NOK AD2527E Grease Seal that you have now.

view full answer...

Answer 8

We have a few types of license plate holders to choose from and you can see all of them on the linked page. You might prefer one design over another for your Exiss horse trailer, such as the CE Smith Tread Plate design #CE26053A As for trailer lights…

view full answer...

Answer 9

I recommend using something like and L-bracket, such as #CE26098G, that you can attach to the top rail near the end of the trailer. Then you can attach a bracket such as #LPL55CB (may have to do some drilling/modify the L-bracket). Then you can…

view full answer...

Answer 10

Those are the wires for the brake magnets. You will need to connect the black wire to the brake controller output wire on your trailer connector and you are correct the white wire will need to be grounded to a clean metal surface on the trailer. I…

view full answer...

Answer 11

Yes, the Curt Echo Mobile Trailer Brake Controller part #C51180 will work perfectly on your 2017 Chevrolet Traverse once you install the T-One Vehicle Wiring Harness part #118271. The only the thing you will need is a bracket for the trailer…

view full answer...