How to Determine Which Trim Insert Is Needed for My 2004 Itasca Suncruiser Motorhome

Question

Question:

I have a 2004 Itasca Suncruiser 33inch motorhome. The molding that covers the screws that hold the rear cap on needs to be replaced. Any ideas as to which molding I need to use? Please advise. Thanks.

asked by: Harold R

0

Expert Reply:

All you're going to have to do to determine which trim insert you need s measure the available width inside your trim.

We currently carry 3/4" # CAM25262 and a 1" trim insert # CAM25202 for you to choose from.

expert reply by: Bryce D

0

Answer 1

The Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide #CAM25202 is designed to fit all the standard trim rails. The rails normally have the lip on either side that the vinyl tucks under. I've attached a photo of this trim to…

view full answer...

Answer 2

The color of the Camco RV Vinyl Trim Insert #CAM25202 is white that is between polar and colonial. For colonial we have the part #CAM25222. Polar is very white and Colonial is an off-white.

view full answer...

Answer 3

The Camco RV Vinyl Trim Insert #CAM25202 that you referenced has an overall width of 1 inch. That's the size of rail it would fit into. I attached a picture that shows it's width for you to see as well.

view full answer...

Answer 4

When replacing your vinyl molding trim you should measure the overall width of the trim. Since yours is 7/8" I recommend going with the 1" trim, and here are the available options in either White or Black: - 25 Feet: White #37210025 or…

view full answer...

Answer 5

I went out to our warehouse to measure the width of the Camco RV Vinyl Trim Insert #CAM25202 that you referenced and found that it is 1 inch thick.

view full answer...

Answer 6

The Alpha Systems Superflex TPO RV Roof Membrane #AL32CV is 30 mils thick. You will need the Alpha Systems RV Roof Replacement Installation Kit #AL74UV to install and seal the membrane on your roof.

view full answer...

Answer 7

Don't worry! Some of the RV products we sell can reasonably be called by multiple names and it can be tough to search for something without knowing the specific term we happen to use. For actual weather-stripping material we have two items shown…

view full answer...

Answer 8

We have checked with Atwood and can confirm for you that the Replacement Black Door #AT91507 or white #AT91386 are a confirmed fit for your 6 gallon Atwood GC6AA-10E water heater.

view full answer...

Answer 9

The best way to select the correct size vinyl trim insert is to measure the trim insert you have now while flat, not the track. We don't really recommend measuring the track as they are not all a standard width. That said, we only offer vinyl…

view full answer...

Answer 10

The torque specs for 9/16" diameter u-bolts like the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles part #APUBR-9 will be a range, from 65 ft. lbs. to 95 ft. lbs. If the tie-plates start to bend inside this range that would be…

view full answer...

Answer 11

We've actually had this one asked before and have consulted with MaxxAir. Even though you can technically install the MaxxFan Deluxe Roof Vent #MA00-06401K wired to a separate switch, it is not recommended. The reason for this is that their fans…

view full answer...

Answer 12

I have another option for you, but the Camco RV Vinyl Trim Insert #CAM25202 is not for windows, entry doors, compartment doors, or vents. We have a few window weather strips available which I have listed below so you can see what size works for you.…

view full answer...

How to Determine Which Trim Insert Is Needed for My 2004 Itasca Suncruiser Motorhome

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching