Diameter of Taylor Made USA Boat Flag Kit Flag Pole

Question

Question:

Part Number 36992: diameter of flag pole? Thank you

asked by: J L

0

Expert Reply:

The dflag pole that comes with the Taylor Made USA Boat Flag Kit # 369921 is 3/4" in diameter. The full dimensions are 24" long x 3/4" diameter.

expert reply by: Robin H

0

Answer 1

Lug Nut torque for the Aluminum Trailer Wheel #AM22654 will be between 90 and 100 foot lbs torque based on the 1/2 x 20 wheel studs and 15 inch aluminum wheels. Because the wheel bolt holes are reinforced with the improved clamp force technology, I…

view full answer...

Answer 2

A 13 inch trailer wheel is likely going to use 1/2 inch lug nuts. The torque spec is the same for a 13 inch wheel whether it is steel or an alloy wheel; 75 to 85 foot pounds. I have included a picture with a handy chart with torque values for you as…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 8

The difference between load ranges varies based on the tire size and brand. When comparing two tires of the same size and brand, a load range D tire will always have a greater weight capacity and psi rating than a load range C. However, when…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Diameter of Taylor Made USA Boat Flag Kit Flag Pole

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching