Overall Width of Tandem Axle Teardrop Trailer Fenders HP64VR

Question

Question:

It says 9 inch width and 1 inch inner and outer rounded edge in the description. So are these 9 inches overall? Or 9 inches plus the 1 inch edges? So 11 inches overall? Thanks.

asked by: Kevin N

0

Expert Reply:

Good question, and the overall width is indeed 9 inches for the Tandem Axle Teardrop Trailer Fenders - Rounded Edges - Steel - 15" to 16" Wheels # HP64VR.

expert reply by: Kyle S

0

Answer 1

If you're looking for a heavy duty fender you'll want to go with steel. I looked up some photos of a McClain ATT-2452 online and the Tandem Axle Teardrop Trailer Fenders part #HP94VR for 14" - 15" wheels or part #HP64VR for 15"…

view full answer...

Answer 2

The smaller section of the Z-Rail for Enclosed Trailer #362417-955 is approximately 3/4" tall, while the larger section is approximately 1-1/4" tall.

view full answer...

Answer 3

A galvanized steel fender like #CE17701G has a corrosion-resistant zinc coating applied to it, while a raw steel fender like #CE17720 does not. Both types can be painted, but it will be easier to paint the non-galvanized part. In either case the…

view full answer...

Answer 4

The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.

view full answer...

Answer 5

To determine the location for the front and rear hangers on your tandem axle trailer you will first need to make sure that you have the correct center point for your equalizer hanger. The center point of your equalizer hanger needs to be located…

view full answer...

Answer 6

Each of the 86-1/2 inch axles we offer, such as the 5,200 lb Dexter Trailer Axle w/ Electric Brakes #8327816-EB and 6,000 lb part #8327826-EB have 71-1/2 inch spring centers. So what you would have to do is get new spring seats welded on at the…

view full answer...

Answer 7

I do have an option for you but there aren't any direct wiring adapters to go from a 4-round to a 7-blade. Therefore, you'll need to remove the 4-round and install a 7-blade which is really your best option since this is far more common for…

view full answer...

Answer 8

The Backing Plate #HP72FR can be cut to match the Tandem Axle Teardrop Trailer Fenders #HP64VR but we do not have any custom backing plates that fit the #HP64VR.

view full answer...

Overall Width of Tandem Axle Teardrop Trailer Fenders HP64VR

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching