Recommended Trailer Wiring Harness for 2014 Subaru Outback Wagon

Question:

Which kit do you recommend for this car? My trailer has conventional side marker lights and LED tail and brake lights. The turn signal and brake light are the same lights on the trailer. I ordered a hitch last week and forgot the harness. Thank you

asked by: Tom S

Helpful Expert Reply:

I recommend using the # C56040 which is a plug-and-play unit, while the # 56146KIT is a hardwired option that would need to splice into the existing vehicle wiring. The connector for the # C56040 is usually located along inside of the drivers side wheel well, as shown in the instructions. I will warn you that Subaru is notorious for varying the location of the connector. You might need to check all the other spots shown in the instructions.

The # C56040 has a 3 amp capacity for the turn signal/brake circuit and a 6 amp capacity for the running light circuit, which will be more than enough for your needs.

I have linked you to the install instructions, and to an install video showing the wiring being installed on a 2014 Outback Wagon.

expert reply by: Mike L