Solution for MaxxFan 4751KS That Won't Open Manually or With Wall Switch

Question

Question:

I have the MaxxFan 4751KS on a 2022 Alliance Avenue 30RLS. The vent lid will not open with the wall control. The manual turn handle wont open it either. It does nothing. There is power to the motor. It almost seems like the motor is seized up. Or could there be something that is making the lid stuck?

asked by: Dennis S

1

Helpful Expert Reply:

It sounds like the operator of your MaxxFan is locked up or damaged since it won't open manually or with the motor. For a replacement you'd need the part # MA10-20281K-1AF and you'd be set.

expert reply by: Jameson C

1

Answer 1

The auto mode has factory default setting to 78 degrees F and adjustable in single digit increments to the highest thermostat setting of 99 degrees. When the fan is turned on due to the auto mode setting, the fan speed will automatically adjust…

view full answer...

Answer 2

I have a solution that I think would work well for you but all of the roof vents we offer for RVs do use either remotes or controllers on the assembly itself. The MaxxFan Plus Roof Vent #MA00-04500K though comes with a wall mount for the remote…

view full answer...

Answer 3

We do have the correct replacement operator mechanism for your MaxxFan Plus model 4751KS, which is the following part: - Replacement Operator Mechanism #MA10-20281K-1AF Instructions are included along with the mechanism.

view full answer...

Answer 4

The model number for fans such as the MaxxAir MaxxFan Mini Roof Vent, #MA00-04401M is listed on the upper side of the assembly itself. Please see the attached image. You will best identify this by opening the vent and climbing on top of the RV.…

view full answer...

Answer 5

Adding skid wheels to your open car trailer is indeed what I recommend to help prevent the trailer from dragging when going up a steep driveway. These are designed specifically for this very purpose and will work well. I recommend taking a look at…

view full answer...

Answer 6

According to the manufacturer's installation instructions for the Equa-Flex Cushioned Equalizers #LC279688, the nut threaded onto the equalizer bolt as well as the nuts threaded onto the shackle bolts should be tightened until they bottom out…

view full answer...

Answer 7

The Roadmaster Comfort Ride Shock Absorbers for Tandem Axle Trailers - 5,200-lb to 7,000-lb Axle #RM-2460 is a great option. The leaf spring kit it was paired with is no longer available separately, so if you want both you would need to get the kit…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept…

view full answer...

Answer 10

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower…

view full answer...

Answer 11

Congratulations on your new truck bed camper! I'm sure you will enjoy it for many years. Sway is a common issue with truck bed campers which can be reduced, but not eliminated. The campers are not particularly aerodynamic and the sway will…

view full answer...

Answer 12

Good morning, Don. The 3/4" wide butyl tape is exactly what we recommend for installing a roof vent such as the MaxxFan #MA00-07000K. We actually sell a roof vent install kit part #344270KITW that comes with sealant, screws and a 30'…

view full answer...

Solution for MaxxFan 4751KS That Won't Open Manually or With Wall Switch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching