Replacement Roof Vent For MaxxAir MaxxFan 4900K

Question

Question:

Do carry model no. Maxxfan 4900k

asked by: Mike F

0

Expert Reply:

I recommend using the MaxxFan Plus Roof Vent # MA00-04500K he MaxxFan 4900k is no longer in production. This is very similar as it has thermostatic control, remote control and rain sensor.

Adding the MaxxAir FanMate RV and Trailer Roof Vent Cover # MA00-955003 will allow you to still use the vent even in the rain. It will attach with the included clips so no drilling is required. It is smoke like the vent cover to allow light to still come in when closed.

expert reply by: Bud M

0

Answer 1

Yes. The Replacement Printed Circuit Board and Switch for MaxxFan Roof Vents #MA10-04301k-v16 is the printed circuit board you need.

view full answer...

Answer 2

If the vent fan you have now is reversible then there should be a button on the assembly next to the other controls. However, if the fan is not reversible then all you need to do is reverse the wires on the motor (not the circuit board) and that will…

view full answer...

Answer 3

For your 4900K model you will want the Replacement Operator Mechanism for MaxxAir MaxxFan Plus or MaxxFan Deluxe Roof Vents #MA10-20281K-1AF since your model isn't opening.

view full answer...

Answer 4

Changing the polarity of the MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-06401K would likely burn out the circuit board. The #MA00-06401K is designed to move air out of your trailer when the vent cover is open or pull air in and circulate the air…

view full answer...

Answer 5

There really isn't any troubleshooting that you can do with a MaxxAir Rain Sensor besides just making sure the vent has a full 12v of power and that the rain sensor cable isn't damaged and is fully plugged in. If it isn't working properly…

view full answer...

Answer 6

If your roof vent lid won't open, even when using the manual lift knob, then the gears of the lift operator are most likely stripped out and the lift operator will need to be replaced. The Replacement Operator Mechanism #MA10-20281K-1AF is…

view full answer...

Answer 7

MaxxAir vents that have an integrated rain sensor, like the MaxxFan Plus Roof Vent #MA00-04500K, do not allow you to override the sensor. If you were to override it you would be allowing rain to hit the motor which could definitely damage it. The…

view full answer...

Answer 8

Yes you are correct the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is the right replacement and measures 18 1/8" long and 16 1/2" wide, which is the same measurements as your current MaxxFan Plus Roof Vent w/…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...