Availability Of a Jeep Fender 11-12 Inches Wide and 20-24 Inches Long

Question

Question:

looking for a jeep style fender 11 to 12 wide 20 to 24 long

asked by: Bernie W

0

Expert Reply:

The Single Axle Jeep Style Trailer Fender # HP25VR is going to be the closest we have to the dimensions you are looking for. This fender is 10" wide, 21" long and 8" tall. Our next largest size Fender # HP76VR is going to be 36" long, 10" wide and 19-1/4" tall.

expert reply by: Bud M

0

Answer 1

I do not have a wheel with these exact measurements. I do have tire and wheel combinations that are 10 inch diameter x 6 inch wide with a 5 on 4-1/2 bolt pattern. A link to selections available attached. The closest we have is the Kenda 205/65-10…

view full answer...

Answer 2

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 3

Hey Matt, it certainly may be possible to upgrade the tires on your utility trailer. Space limitations are the main thing to consider though. Our rule is that you want at least 3" between the tire and the wheel well/fender, and you want at least…

view full answer...

Answer 4

The Titan 60ZX7000 brake actuator is a Model 60 actuator, and you do have the correct part for a replacement master cylinder: - Replacement Master Cylinder Assembly for Titan Model 60 and Aero 7500 Brake Actuators - Drum #T4395100 So this will work…

view full answer...

Answer 5

The plug to connect the #3014-P harness in your 2019 Jeep Cherokee to is behind a black cover that is just to the left of the steering column right above where the carpeting ends. You need to remove the black cover. Check out the picture I attached.…

view full answer...

Answer 6

You will need to use a circuit tester like part #PTW2993 to find the circuit that only sees voltage when the brakes are applied and use it for the stoplight circuit for the #46365. It sounds like maybe you haven't found the correct circuit to use…

view full answer...

Answer 7

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

view full answer...

Answer 8

If the rear jacks on your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590 aren't retracting then you should be getting an error on the touch pad screen. This is typically the result of the wiring being interrupted. Try…

view full answer...

Answer 9

The 16-Gauge Steel, Single-Axle Trailer Fender #HP36VR is 9 inches wide measured from outside edge to outside edge. It is 32 inches long from outside front edge to outside rear edge (at the bottom of the fender). And it is 15 inches tall measured…

view full answer...

Answer 10

The etrailer Single-Axle Trailer Fender, Part #HP99VR, is shown in the attached photo with several measurements indicated. I have also included a video link which helps to show certain dimensions that are difficult to convey on the photo. The overall…

view full answer...

Answer 11

I don't have a build sheet for the #HP99VR fender but I'd be happy to provide any dimensions you might need. If you can reply with the exact dimensions you're needing. I've provided a photo showing the length, width and height of the…

view full answer...