bing tracking image
Q & A Icon

Does the Voyager WiSight Wireless Backup Camera System Work For an RV That is Prewired For Voyager  

Question:

Hi. I was told that this camera will work for my current pre-wired RV backup camera. I have a black plate under the Voyager Plate cover, that has 4 holes that is round to plug into ::. This will work for my current setup correct? I just wanted to know where will the excess cable wires be stored once plugged in?

0

Expert Reply:

Yes, the Voyager WiSight 2.0 Wireless Backup Camera System # ASA37YR will work with your RV that is prewired for a Voyager camera system. The back of the camera has a 4-pin plug that will plug directly into the 4-hole plug that is in the black plate under the Voyager plate. The # ASA37YR camera has a little cutout that fits right over the black plate that is under the Voyager plate.

I am not sure what excess cable you have because the # ASA37YR camera does not have a cable that runs from the camera to the plug. The 4-pin plug on the backside of the camera lines up and plugs into the 4-hole plug without a cable spanning the gap. The only cable in the # ASA37YR system is the power wire for the monitor which will be inside the tow vehicle.

I have included a video that goes over the installation starting around the 9:00 minute mark.

expert reply by:
0
Scott S

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>