How is Positive Offset Measured on HWT Star Mag Wheel with Offset # AM22691

Question

Question:

When you mention 5inch offset is that from center of rim to lug bolt mounting face?

asked by: Paul

0

Expert Reply:

Wheel offset is always measured from the center line of the rim to the hub face. In the case of Aluminum HWT Star Mag Trailer Wheel with +5 mm Offset # AM22691 the rim provides 5-inches of positive offset, which moves the tire surface closer to the vehicle.

expert reply by: Adam R

0

Answer 1

The overall diameter and width of a Provider #TA99VR 30.79 inches diameter by 9.25 inches wide. A 235/80R16 is 9.3 inches wide and has an outer diameter of 30.8 inches so a bit shorter but a little bit wider. The #PRG80235 is a 235/80R16 that would…

view full answer...

Answer 2

I went out to the warehouse with a handful of sockets to see which size fits over Flange Wheel Nut - 5/8" Item #95188. It takes a 1-1/8 inch socket. I have linked a video review of this nut for you.

view full answer...

Answer 3

It sounds like you're needing the Vesper Steel 16" wheel. This comes with a 4.77" Pilot Hole as part #TA56FR or a 4.88" Pilot Hole as part #MX89FR. These have a 16" diameter and a 6" width which will fit just fine for…

view full answer...

Answer 4

The trailer tire and wheel combo to fit your 10K Dexter axle would be the Taskmaster Provider ST235/85R16 Trailer Tire with 16" Vesper Silver Dual Wheel, #TA45FR. This wheel can be used as either the inner or outer wheel of a dual-wheel setup.

view full answer...

Answer 5

It sounds like you have an intermittent short somewhere in your braking system. The readings you are seeing are correct, because the short is intermittent. An intermittent problem can be very difficult to find, but your best bet is to physically…

view full answer...

Answer 6

We do offer frame-mount trailer hitches for RVs and these are available in either bolt-on or weld-on varieties. You can click on the included link to see all such items, such as the Curt #C13701 that carries a 500-lb tongue weight (TW) rating and a…

view full answer...

Answer 7

It is possible that the Vesper Steel Dual Trailer Wheel - 16" x 6" - 8 on 6-1/2 - 4.88" Pilot - Silver #MX89FR will work on your 2013 Itasca 25B built on the Ford E-350 chassis, but you will need to confirm the bolt pattern of your…

view full answer...

Answer 8

The pilot diameter is measured as the diameter of the large hole in the center of the wheel. The Dexstar #AM20790 steel dual trailer wheel you referenced has a 4.88 pilot diameter. So which pilot diameter would you need? To figure that out, I would…

view full answer...

Answer 9

The Lionshead Steel Dual Wheel, 4.75" Pilot - Silver, Item #LHHA420 is a 16" x 6" wheel with an 8 on 6-1/2 bolt pattern, so as long as your Class C motorhome wheels have the same bolt pattern and are the same 16" x 6"…

view full answer...

Answer 10

Thanks for the picture! The Lionshead Steel Dual Trailer Wheel, item #LHHA420, is 16" by 6" and has the same 8 on 6-1/2 lug pattern. Your LT25/75R16 tires fit wheels that have a width of 6" - 7", so this wheel will work great. To…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

How is Positive Offset Measured on HWT Star Mag Wheel with Offset # AM22691

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching