What Size Fuse Does The Handheld Remote Control Require for the Tekonsha Prodigy RF Trailer Brake

Question

Question:

What size fuse goes into the power cord for a Prodigy RF brake controller? Thanks

asked by: Roger K

0

Expert Reply:

The Handheld Remote # TK27FR for the Tekonsha Prodigy RF uses a 1amp AGC or MGC fuse. This is something you will need to source locally as the smallest fuse we have is 5amp in our Fuse Kit # PT92FR.

expert reply by: Bud M

0

Answer 1

Your best option would be to install the 12 volt outlet kit part #RM-9332 on your vehicle so that you can have the correct outlet to power the remote of the Prodigy RF part #TK94FR that you referenced. This wires directly to the battery and gives you…

view full answer...

Answer 2

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 5

Thanks for the picture of what you have and the info you listed. The correct wheel you need is the part #AM20794 that you referenced.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?

view full answer...

Answer 8

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 9

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 10

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

What Size Fuse Does The Handheld Remote Control Require for the Tekonsha Prodigy RF Trailer Brake

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching