Too Much Play in Pin for Lead Landing Gear Leg  

Have you checked the battery that is powering the landing gear? Generally when the motor is running but you cannot get the landing gear to raise the gearbox is the issue but since you have replaced that the next step is to check your battery.…

For the Venture landing gear lead leg on your 2004 Keystone Montana you can use repair kit #LC146059. If you ever need the repair kit for the follower leg it is #LC146060.

Though I could not find anything about the T46059 repair kit you referenced, but odds are the jack isn't rated high enough for the weight of your trailer. Or there is more than just the gears that need to be replaced. What you will probably…

As long as one of the wires coming from the back of the hub is a ground and the other is a power, it does not matter which wire on the magnet goes to which wire from the back of the hub. I have included a link to a video of a magnetic brake…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…