Replacement Brake Kit and Boot for Power Gear Motor 1010001093

Question

Question:

Im looking for 2 power gear Brake Service Kit #1010001289 and 2 Boot Replacement Kit #1010001232. The power gear motor is p/n 1010001093 and s/n 0710624898.

asked by: Eric

0

Expert Reply:

Yes, we do offer both the Electric Jack Brake Replacement Kit part # LC87VF and the Electric Jack Motor Boot part # LC47VF. I got these added to our system for you.

expert reply by: Conner L

0

Answer 1

The correct replacement for a Power Gear Motor 1010001093 is the Replacement Motor for Lippert Power Gear Electric Leveling Jack System part #LC89CJ.

view full answer...

Answer 2

For your Roadmaster Sterling Tow Bar #RM-576 the replacement stinger part #910019-40 is the correct replacement. The nut is included so if you need a horizontal bolt too you'd also need the part #RM350191-00.

view full answer...

Answer 3

There could be many possibilities that are causing the pulsating of your brakes on your 2008 Ford E350. A few possibilities to start with would be to use a circuit tester like the Quickee Tester, part #PTW2993, and check the connection of your…

view full answer...

Answer 4

We do have a solution for you but unfortunately the rubber boot that you referenced isn't available as a replacement part from Lippert. If that is in bad shape then you will need to replace your motor. The correct replacement motor for the…

view full answer...

Answer 5

You will need the Replacement Motor and Wiring Harness for Lippert Power Gear Electric RV Leveling Jacks #LC47VF. This is the service kit Lippert has to replace the boot on your Power Gear jack motor 1010000155.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Brake Kit and Boot for Power Gear Motor 1010001093

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching