Will The SumoSprings Trailer Helper Springs Fit A 2022 Jayco North Point 382FLRB 5th Wheel

Question

Question:

Will this part fit my 2022 Jayco Northpoint 382FLRB? I have 7k twin axles. Thanks,

asked by: Danny G

0

Expert Reply:

The SumoSprings Trailer Helper Springs w/ Line Relocation Bracket # SS26MV could possibly be the correct kit for your 2022 Jayco North Point 382FLRB 5th wheel, you'll just need to verify the orientation of your leaf springs to the axles.

The # SS26MV are designed for overslung axles, which means that the leaf springs will sit on top of the axle. If you have underslung axles (leaf springs below the axle) then you'll just need part # SS33HR instead. These kits are for a single axle only so you'll need two to complete the installation on both axles.

expert reply by: Kevin C

0

Overslung-Underslung
(click to enlarge)

Answer 1

The SumoSprings Trailer Helper Springs #SS26MV are the correct design and weight rating for your 2021 Grand Design Reflection 310RLS. You will need to verify that the u bolt plate is smaller than 5-1/2" wide x 3/4" thick for it to fit…

view full answer...

Answer 2

If your 7K axles have overslung leaf springs (sits atop the axle), the SumoSprings TSS-107-47 which we sell as part #SS26MV would for well for you. The kit includes a line relocation kit in case there's a wiring harness, water or gas line in the…

view full answer...

Answer 3

First I recommend the SumoSprings Trailer Helper Springs #SS26MV be added to your axles. As these are designed for a single axle you will need 2 of the kits. It seems strange that the springs would be damaged as they are not that old and are likely…

view full answer...

Answer 4

You may be experiencing some wear in the suspension components that can cause tire wear and also be a symptom or cause the axle to be misaligned. Inspect your suspension components and if any of the holes where hardware goes is egg-shaped, that…

view full answer...

Answer 5

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 8

We have one option that will work for you. The Trailer Hub and Drum Assembly - 4,400-lb E-Z Lube Axles - 10" Diameter - 6 on 5-1/2 #8-407-5UC3-EZ uses inner bearing #L68149 and outer bearing #LM67048 so it would work perfectly on your spindle.…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Most critical to trailer tire performance and durability are 1) proper inflation 2) observance of the tire's rated load capacity and 3) observance of the tire's speed rating. If either of these factors is off the mark then the tire will tend…

view full answer...

Answer 12

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...