Replacement Ramp for etrailer Aluminum Motorcycle Carriers

Question

Question:

Hi. I’ve lost the ramp to part e56UR Aluminum Motorcycle Carrier. Can I buy a replacement ramp only? Thanks!

asked by: Grant M

0

Expert Reply:

Yes, you can buy a replacement ramp for the etrailer Aluminum Motorcycle Carrier item # e56UR. You will want item # e92TR.

expert reply by: Jerred H

0

Answer 1

I did some searching around on the internet and came up with a few interesting tips to prevent rodents from eating vehicle/trailer wiring. Here is what I found: Noise will keep the rodent's away. So a portable radio would work for this. Flashing…

view full answer...

Answer 2

The EcoHitch Hidden Trailer Hitch item #306-X7350 you were looking at is confirmed to fit your 2018 Subaru Impreza. It bolts to your Subaru with included hardware. I really like this hitch because it installs behind your rear bumper cover leaving…

view full answer...

Answer 3

You are correct that there are a couple 2 inch trailer hitches available for your 2018 Subaru Impreza, the EcoHitch #306-X7350 and the Draw-Tite #76209. The primary difference between the two models is their visibility behind the vehicle which is why…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Replacement Ramp for etrailer Aluminum Motorcycle Carriers

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching