Is the 6K Curt MV Weight Distribution System Too Much for a 3K Trailer

Question

Question:

I have a 2021 Kia Sorento EX. Tow capacity 3500lbs. Camper being towed is 2900lbs. Would the Curt 6k lb weight distribution hitch be ok or is it too much?

asked by: David

0

Expert Reply:

The tongue weight of a 3,000 lb trailer is going to be between 300 lbs and 450 lbs. Therefore, the Curt MV Weight Distribution System part # C17050 which is rated for up to 600 lbs would be a bit overrated but it will still work for you. It's better to overrated than underrated when it comes to weight distribution systems and this also leaves you more room for error to upgrade down the road.

Please note, in order to complete this system you will also need the 2" Hitch Ball part # A-90.

expert reply by: Conner L

0

Answer 1

The difference between the two Fastway weight distribution systems you mentioned is the bar style of either. The Fastway part #FA92-00-0600 uses trunnion bars which many prefer as you get more ground clearance with them and the part #FA94-00-0600 is…

view full answer...

Answer 2

The Curt MV Weight Distribution System part #C17050 does not have sway control so reversing is not as big of an issue although the trailer still needs to remain relative straight. If you need to turn and backup it is recommend to unhook the spring…

view full answer...

Answer 3

The inner depth of the Trailer Wheel Center Cap, part #319EZ is 3-1/8 inches to the tabs on the removable plug on the end of the cap. I am including a picture of the measurement. To be able to determine if the #319EZ center cap will fit a boat…

view full answer...

Answer 4

I would be happy to help! First the Curt MV Weight Distribution Hitch #C17050 you were looking at would be a bit stiff with the 440lb tongue weight you mentioned for your 16' Airstream, but is that figure what Airstream lists as the tongue…

view full answer...

Answer 5

The Trailer Wheel Center Cap, #319EZ, is mainly used for decoration and does not include a seal so it is very possible for water to get behind there and not completely drain. This cap is not designed to keep water out of the hub, for that you would…

view full answer...

Answer 6

Wheel center caps are chosen based on the diameter of the wheel's pilot hole (the hole in the center of the wheel) as shown in the picture I linked for you. You'll just want to measure your wheels' pilot holes. If you need a digital…

view full answer...

Answer 7

I have a solution for you, but the Pro Series Weight Distribution System part #49570 that you referenced is not recommended for use with surge brakes if you are using a sway control bar like #83660. Instead, for a similar rated system that would be…

view full answer...

Answer 8

Any time you are towing a trailer that has a fully loaded weigh that is over 50 percent of the vehicle's gross weight, a weight distribution system is recommended. If your vehicle weighs less than 6,000 lbs, a weight distribution system and…

view full answer...

Answer 9

The Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round #FA94-00-1000 weighs 86 lbs. Once you add the hitch ball like #19286 will add 4 lbs so you'll be at 90 lbs total.

view full answer...

Answer 10

Yes, a set of detailed install instructions come with the Curt Weight Distribution system part #C17052 that you referenced. I attached a link to them if you wanted to check them out now. I also attached a review video for this product and a couple…

view full answer...

Answer 11

The weight distribution system you use needs to be rated for the tongue weight of your 2017 Dutchmen Kodiak Ultra-Lite 283BHSL. The #RE94FR has a tongue weight range of 400-800 lbs and your dry tongue weight is 754 lbs so you will easily exceed the…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...