How to Tell if AMPLock Trailer Coupler Lock Will Fit Trailer Coupler

Question

Question:

How do I know if this will work for my trailer?

asked by: Mac

0

Expert Reply:

Great question!

The AMPLock Trailer Coupler Lock # AMP44FR works for couplers that connect to a 2-5/16" hitch ball and the coupler has a flat lip design. This is pretty standard for trailer couplers but I'm also linking a review video of this coupler lock for you to check out. If you take note at the start of the video you'll see the flat lip design I was talking about.

If you have the flat lip coupler but you use a 2" hitch ball to tow then you can use the part # AMP64FR instead. This is the same thing as what you asked about just with a smaller hitch ball. I'm attaching a review video for this lock as well.

expert reply by: Jon G

0

Answer 1

When continuing to experience sway while using the Blue Ox SwayPro Weight Distribution w/ Sway Control - Clamp On - 10,000 lbs GTW, 1,000 lbs TW #BXW1000, I recommend making adjustments. I don't recommend starting with making changes to your…

view full answer...

Answer 2

I did some research and found that the Erickson O-Track Cargo Control System like part #EM59133 is very similar to the L-Track systems you referenced. The Erickson O-Track is 18 inches long and includes 2 Spring-loaded O-ring clips and mounting…

view full answer...

Answer 3

The Tow-Rax system is compatible with the Erickson O-Track System and vice versa. The weight capacities/restrictions are based on the attachments themselves, so those individual capacities are what you will want to pay attention to when interchanging…

view full answer...

Answer 4

There are only two Tow-Rax Tie-Down Anchors, the Tie-Down Anchor for Tow-Rax L-Tracks part #TWSPSSTD which is designed to be used with Tow-Rax L-Tracks like part #TWSP6DTAB and the Tow-Rax Tie-Down Anchor for Tow-Rax Low-Profile Floor Tracks part…

view full answer...

Answer 5

When the battery dies on the Galeo Pro GPS Tracking Device #GA94FR you have to replace the sensor as they do not offer a replacement battery. The battery is hardwired into the unit and not something that can be replaced.

view full answer...

Answer 6

In order to determine the correct wheel stabilizer for your tandem axle trailer, you need to know the spacing you have between your wheels, as there isn't a standard spacing for trailers based on size. So all you need to do is take a quick…

view full answer...

Answer 7

Thank you for clearly explaining your intended use for the ramps you want for your 10K tandem torsion axle trailer. The highest-rated ramps we offer have a 6000-lb capacity. All are shown on the linked page. These vary in width, length and lift.…

view full answer...

Answer 8

Your 2019 Chevrolet Corvette has a 18 degree approach angle. This will allow you to use the Race Ramps Rally Ramps #RR-30 as they are capable or an approach angle down to 16 degrees.

view full answer...

Answer 9

The #RR-30 will give you an extra 5 inches of height, so they should work perfectly for you since you were looking to gain an extra 4-5 inches of height. The ramps are compatible with vehicles weighing up to 6000 lbs. The ramps are also lightweight…

view full answer...

Answer 10

The Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle Trailers #UF21-001070 is a wheel chock system that performs the function of a traditional wheel chock, except that by its design it eliminates any movement and is lockable to deter…

view full answer...

Answer 11

For your 2021 GMC Sierra AT4 I recommend the Longview Towing Mirrors - Slip On - Driver and Passenger Side #LO54FR. These are a custom-fit and confirmed to work with all models of the 2021 Sierra 1500. These slide over your factory mirrors and…

view full answer...

How to Tell if AMPLock Trailer Coupler Lock Will Fit Trailer Coupler

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching